Control Manifold - Install
安装步骤
Show/hide table
所需工具     | |||
---|---|---|---|
工具     | 零件号     | 零件名称     | 数量     |
A     | 138-7573     | 连接支架     | 3     |
B     | 1P-2420     | 变速箱修理架     | 1     |
C     | -     | 螺杆 M10 - 1.5 by 250mm 长     |
2     |
注: 清洁度是一项重要的因素。 组装之前,使用清洗剂彻底清洁所有零件。 让零件风干。 不要使用抹布擦干零件。 棉绒可能会留在零件上,从而引发故障。 检查所有零件。 如果任何零件磨损或损坏,则使用新零件进行更换。 污垢及其他杂质可能损坏精密部件。 组装步骤应在清洁的工作面上进行。 务必盖好部件并采取适当保护措施。
注: 检查 O 形密封圈、垫片和密封件有无磨损或损坏。 如有必要,更换这些部件。
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 使用工具 (C) 辅助定位控制歧管 (7) 。 安装螺栓 (9) 和螺栓 (8) 。 将螺栓 (9) 和螺栓 (8) 拧紧至扭矩 55 ± 10 N·m (41 ± 7 lb ft)。
Show/hide table
图 1 | g01364830 |
- 连接线束组件 (10) 。
- 如有必要,安装滤清器组件 (6) 和 O 形密封圈。 请参考操作和保养手册, "机油滤清器(变速箱)- 更换"。
Show/hide table
图 2 | g01364803 |
- 将滤网和磁性滤清器 (5) 安装到控制歧管 (6) 中。 将 O 形密封圈 (4) 和盖 (3) 定位到控制歧管 (6) 上。 安装螺栓 (2) 。 拧紧螺栓 (2) 至扭矩 28 ± 7 N·m (21 ± 5 lb ft)。
- 将工具 (A) 和适当的起吊设备连接到变速箱 (1) 上。 变速箱 (1) 的重量约为 340 kg (750 lb)。 使用工具 (A) 和适当的起吊设备从工具 (B) 拆下变速箱 (1) 。
Show/hide table
图 3 | g01364812 |
Caterpillar Information System:
2007/04/30 New Bracket for the High Pressure Fuel Line {1252}
TA19 and TA22 Transmissions Power Train Electronic Control System MID 039 - CID 1409 - FMI 06
TA19 and TA22 Transmissions Power Train Electronic Control System MID 039 - CID 1409 - FMI 05
TA19 and TA22 Transmissions Power Train Electronic Control System MID 039 - CID 1409 - FMI 03
TA19 and TA22 Transmissions Power Train Electronic Control System MID 039 - CID 1408 - FMI 06
TA19 and TA22 Transmissions Power Train Electronic Control System MID 039 - CID 1408 - FMI 05
C13 and C15 On-highway Engines ARD Purge Air - Test
TA19 and TA22 Transmissions Power Train Electronic Control System MID 039 - CID 1408 - FMI 03
TA19 and TA22 Transmissions Power Train Electronic Control System MID 039 - CID 1407 - FMI 06
TA19 and TA22 Transmissions Power Train Electronic Control System MID 039 - CID 1407 - FMI 05
TA19 and TA22 Transmissions Power Train Electronic Control System MID 039 - CID 1407 - FMI 03
TA19 and TA22 Transmissions Power Train Electronic Control System MID 039 - CID 1406 - FMI 06
C9 Agricultural Engine for Challenger Tractors Electrical Power Supply - Test
C7.1 (Mech) Industrial Engine Engine Rating Conditions
C15 and C18 Industrial Engines Ether Starting Aid - Test
CX28 On-Highway Transmission Control Manifold - Disassemble
CX28 On-Highway Transmission Control Manifold - Assemble
C7.1 (Mech) Industrial Engine Engine Rating Definitions
3412E, C30 and C32 Marine Engines Auxiliary Water Pump - Assemble
2007/05/14 New Product Link Software Is Now Available {7606, 7620}
C9 On-highway Engine Fuel Injection Pump - Remove
C9 On-highway Engine Fuel Injection Pump - Install
C18 Marine Auxiliary Engines Fuel Temperature Is High
C7 and C9 On-highway Engines Emergency Vehicle Engine Features