D6T Track-Type Tractor Monitoring System Caterpillar

Illustration 1	g02615483
Components of the Communication Adapter 3 Gp (317-7484) are listed: (1) Current version of Cat® Electronic Technician (Cat ET) Service Tool software for use with a Windows-based personal computer (2) 317-7485 Control Gp-Electronic (Com Adapter 3) (3) 327-8981 Cable As. (Data Link Cable CA3) (4) 370-4617 Cable As. (CA3 PC USB Cable)

Perform the following procedure to flash program an ECM. An ECM is flashed to upgrade the software. An ECM must also be flashed if an ECM has been replaced. The Cat^® Electronic Technician (Cat ET) Service Tool contains the program WinFlash. WinFlash is used to load software into an ECM.

1. Connect the data link cable between the communication adapter and Cat ET.

2. Connect the data link cable between the communication adapter and the diagnostic connector of the machine.

3. Turn the disconnect switch and the key start switch to the ON position.

4. Set the implement lockout to the LOCKED position.

5. Make sure that the transmission direction switch is in the neutral position.

6. Verify that the engine is not running.

7. Use WinFlash to load the software.