Power Train Oil Cooler - Remove and Install
开始:
- 拆下右侧检修门和盖。
Show/hide table
热的冷却液、蒸汽和碱会造成人身伤害。 在工作温度下,发动机冷却液是热的而且处在压力下。 散热器和所有到加热器的管路或发动机中都有热的冷却液或蒸汽。 与它们的任何接触都会造成严重烫伤。 只有当发动机停机且冷却系统压力盖已经冷却到可以徒手触摸时,再慢慢拆下冷却系统压力盖以释放压力。 不要试图在冷却液还热的时候去拧紧软管接头,软管会脱落而造成灼伤。 警告:冷却系统的冷却液添加剂含碱。 应避免它与皮肤和眼睛接触。 |
Show/hide table
热油和热的部件可能会导致人身伤害。 不要让热油或热的部件与皮肤接触。 |
- 有关排放和加注步骤,请参考操作和维护手册, "动力传动系机油 – 更换"。
- 请参阅操作和保养手册, "冷却系统冷却液(ELC)- 更换"以了解正确的排放和加注步骤。
Show/hide table
图 1 g02364134 典型示例。
已拆下清洁排放模块以便拍照。 - 拆下软管 (1) 和 (3)。 拆下管组件 (4)。
- 将线束组件 (5) 置于一旁,然后拆下机油滤清器 (2)。
Show/hide table
图 2 g02364316 Show/hide table图 3 g02364317 - 断开软管组件 (7) 和软管组件 (6)。
- 断开软管组件 (9) 和管组件 (8)。
Show/hide table
图 4 g02364396 - 拆下卡箍 (10) 并断开软管组件 (11)。
Show/hide table
图 5 g02364457 - 拆下缸体组件 (12) 并对另一侧重复此步骤。
Show/hide table
图 6 g02364467 Show/hide table图 7 g02364468 - 将适当的起吊设备连接到动力传动系机油冷却器 (15) 上。 动力传动系机油冷却器 (15) 的重量约为
50 kg (110 lb) 。 - 拆卸管组件 (13)。
- 拆下螺栓 (14) 和 (16)。 拆下动力传动系油冷却器 (15)。
- 按与拆卸相反的顺序安装动力传动系机油冷却器 (15)。
Caterpillar Information System:
994K Wheel Loader Lifting and Tying Down the Machine
525D, 535D, 545D, 555D Wheel Skidder Power Receptacle
994K Wheel Loader Fuel System Water Separator - Check/Drain
C3.4B Engines Glow Plug Starting Aid - Test
AD45B Underground Articulated Truck Cab Air Filter - Clean/Replace - If Equipped
826K Landfill Compactor, 825K Soil Compactor and 824K Wheel Dozer Engine Supplement Hydraulic Tank Oil - Retain
D6T Track-Type Tractor Engine Supplement Crankshaft Front Seal and Wear Sleeve - Remove and Install
D6T Track-Type Tractor Engine Supplement Engine Front Support - Remove and Install
986H Wheel Loader Engine Supplement Steering Frame Lock - Separate and Connect
D6T Track-Type Tractor Engine Supplement Crankshaft Vibration Damper and Pulley - Remove and Install
C27 and C32 Engines for Caterpillar Built Machines Housing (Rear) - Remove and Install
621K, 623K and 627K Wheel Tractor-Scrapers Engine Supplement Air Control Valve (ARD Combustion) - Remove and Install - Scraper
D6T Track-Type Tractor Engine Supplement Engine Trunnion - Remove and Install
D6T Track-Type Tractor Engine Supplement Water Temperature Regulator - Remove and Install
D6T Track-Type Tractor Engine Supplement Engine Oil Pan - Remove and Install
525D, 535D, 545D, 555D Wheel Skidder Articulation Bearings - Lubricate
D6T Track-Type Tractor Engine Supplement Engine Oil Pump - Remove and Install
D6T Track-Type Tractor Monitoring System Module - Flash Program
D6T Track-Type Tractor Engine Supplement Water Pump - Remove and Install
525D, 535D, 545D, 555D Wheel Skidder Ether Starting Aid Cylinder - Replace - If Equipped
Cat® Grade Control for D6T Track-Type Tractors Symptom Troubleshooting
C27 and C32 Engines for Caterpillar Built Machines Turbocharger Outlet Pressure Sensor - Remove and Install
525D, 535D, 545D, 555D Wheel Skidder Hydraulic System Oil Level - Check
994K Wheel Loader Fuel System Water Separator - Replace