Voltage Adjustment Range - Calibrate
Show/hide table
| |
| Illustration 1 | g00825354 |
|
VR6 Voltage Regulator (1) Factory calibration adjustment (2) Voltage adjustment | |
Show/hide table
| |
| Illustration 2 | g01021519 |
Show/hide table
 |
|
The Cat VR6 presents an electrical shock/electrocution hazard. This hazard will cause serious injury or death. Service by trained personnel only. The terminals and heat sinks are live at hazardous voltages when power is applied and for up to 8 minutes after power is removed. |
Show/hide table
| NOTICE |
|---|
|
Do not operate generator at a voltage greater than 5% above the name plate rating. |
The factory calibration adjustment (1) should be used by the factory technicians only. The following procedure can be used if the factory calibration has been disturbed:
- Remove the seal from the factory calibration adjustment (1).
- Start the genset.
- Run the genset at no load.
- Turn the factory calibration adjustment (1) in a fully counterclockwise direction.
- Turn the voltage adjust potentiometer (2) in a fully clockwise direction.
- Slowly turn the factory calibration adjustment (1) CW until the voltage on 20-22-24 is 252 ± 1 VAC for 60 Hz (226 ± 1 VAC for 50 Hz).
- Turn the voltage adjust potentiometer (2) CCW.
- Verify that the voltage on 20-22-24 is between 156 VAC and 180 VAC. The unit is calibrated.
- Seal the factory calibration adjustment (1).
Caterpillar Information System:
VR6 Voltage Regulator Voltage Droop Control
VR6 Voltage Regulator Voltage Regulator - Replace
3500 Engines Air Inlet and Exhaust Lines
C0.5, C0.7, C1.1, C1.5, C1.6 and C2.2 Industrial Engines Engine Design
C11 and C13 Industrial Engines Inlet Manifold Temperature Sensor
3500B Locomotive Engines Refill Capacities and Recommendations
3500B Locomotive Engines Manual Stop Procedure
TA19-M2WD and TA19-M4WD (Delta) Agricultural Transmission Power Train Electronic Control System Transmission, SPN 738 - FMI 6
TA19-M2WD and TA19-M4WD (Delta) Agricultural Transmission Power Train Electronic Control System Transmission, SPN 738 - FMI 5
TA19-M2WD and TA19-M4WD (Delta) Agricultural Transmission Power Train Electronic Control System Transmission, SPN 738 - FMI 3
TA19-M2WD and TA19-M4WD (Delta) Agricultural Transmission Power Train Electronic Control System Transmission, SPN 737 - FMI 6
TA19-M2WD and TA19-M4WD (Delta) Agricultural Transmission Power Train Electronic Control System Transmission, SPN 737 - FMI 5
VR6 Voltage Regulator Voltage - Adjust
VR6 Voltage Regulator Remote Voltage Control
VR6 Voltage Regulator Radio Frequency Interference Filter
VR6 Voltage Regulator Power Factor Regulation and KVAR Regulation
VR6 Voltage Regulator Service Tools
VR6 Voltage Regulator Exciter Field - Flash
VR6 Voltage Regulator Stability - Adjust
VR6 Voltage Regulator Knee Frequency - Adjust
TA19-M2WD and TA19-M4WD (Delta) Agricultural Transmission Power Train Electronic Control System Transmission, SPN 739 - FMI 3
TA19-M2WD and TA19-M4WD (Delta) Agricultural Transmission Power Train Electronic Control System Transmission, SPN 739 - FMI 5
TA19-M2WD and TA19-M4WD (Delta) Agricultural Transmission Power Train Electronic Control System Transmission, SPN 739 - FMI 6
Reuse & Salvage for Valvetrain Components {1102, 1108, 1109, 1121, 1123} Reuse & Salvage for Valvetrain Components {1102, 1108, 1109, 1121, 1123}