- Wheel Loader:
- 950H (S/N: N1A1-UP; M1G1-UP; J5J1-UP; K5K1-UP)
- 962H (S/N: N4A1-UP; M3G1-UP; J6J1-UP; K6K1-UP)
- 966H (S/N: A6D1-UP; A6G1-UP; A6J1-UP; TAL1-UP)
- 972H (S/N: GTA1-UP; A7D1-UP; A7G1-UP; A7J1-UP)
- 980H (S/N: MHG1-UP; A8J1-UP; JMS1-UP)
A new 341-7558 Tag is now being utilized to communicate the status of the implement work tool configuration and calibration when machines are shipped. On all 950H-980H machines, the implement configuration and calibration tag is being installed on the electro-hydraulic control levers. This tag states that configuration and calibration of the implement control system is required when the work tool is installed.
 | |
| Illustration 1 | g02002009 |
There is a perforated portion at the bottom of the tag that will be removed if the machine was configured and calibrated with the work tool that was installed at the factory. If the work tool was not installed at the factory or the factory installed work tool is changed the implement configuration and calibration must be performed after the work tool is installed. Performing the configuration and calibration procedures are expected as part of the predelivery inspection. The performance of these procedures shall not be submitted as a warranty claim.
There are several versions of the tag which support different combinations of languages. The appropriate tag will be installed on the machine from the factory.