Note: Cleanliness is an important factor. Before assembly, thoroughly clean all parts in cleaning fluid. Allow the parts to air dry. Do not use wiping cloths or rags to dry parts. Lint may be deposited on the parts which may cause trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement. Dirt and other contaminants can damage the precision component. Perform assembly procedures on a clean work surface. Keep components covered and protected at all times.
Note: Check the O-ring seals, the gaskets, and the seals for wear or for damage. Replace the components, if necessary.
- Install O-ring seals (14) onto solenoid (13).
Show/hide table
Illustration 2 g01474813 - Install solenoid (13), retainer (12), and bolts (11).
Show/hide table
Illustration 3 g01474756 - Install the O-ring seal and orifice (10).
Show/hide table
Illustration 4 g01474815 - Install O-ring seals (9) onto solenoid (5).
Show/hide table
Illustration 5 g01474752 Show/hide tableIllustration 6 g01458207 Show/hide tableImproper assembly of parts that are spring loaded can cause bodily injury.
To prevent possible injury, follow the established assembly procedure and wear protective equipment.
- Install poppets (7), spring (8), O-ring seals (6) and plugs (1). Tighten plugs (1) to a torque of
105 to 115 N·m (77 to 84 lb ft) . - Install the O-ring seal and plug (4). Install solenoid (5), retainer (2), and bolts (3).
Illustration 1 | g01474754 |
End By:
- Install the control manifold. Refer to Disassembly and Assembly, "Control Manifold - Install (Return)".