243-1733 Output Transfer Gear Group (Standard Steering)
 | |
| Illustration 1 | g01430050 |
(1) Torque for speed sensor ... 37 ± 4 N·m (27 ± 3 lb ft)
(2) Torque for level sensor ... 22 ± 3 N·m (16 ± 2 lb ft)
 | |
| Illustration 2 | g01430049 |
View A-A | |
(3) Install the lip seal even with the face of the bearing cage. Lightly lubricate the lip of the seal with the lubricant that is being sealed.
(4) Lubricate the bore with a minimal amount of the lubricant that is being sealed.
(5) Torque for the two bolts ... 475 ± 50 N·m (350 ± 37 lb ft)
(6) Apply 5P-3413 Pipe Sealant to threads of drain assembly.
(7) Torque for the plug of the drain assembly ... 100 ± 10 N·m (75 ± 7 lb ft)
Note: Use 4C-8563 Drain Adapter in order to open the drain valve.
Note: Refer to the Disassembly and Assembly manual for the instructions in order to set the preload for the input shaft bearings.
249-0218 Transfer Gears and Case Group (Secondary Steering)
 | |
| Illustration 3 | g01430367 |
(1) Torque for speed sensor ... 37 ± 4 N·m (27 ± 3 lb ft)
(2) Torque for level sensor ... 22 ± 3 N·m (16 ± 2 lb ft)
(8) Torque for six bolts ... 55 ± 10 N·m (40 ± 7 lb ft)
 | |
| Illustration 4 | g01430442 |
(3) Install the lip seal even with the face of the bearing cage. Lightly lubricate the lip of the seal with the lubricant that is being sealed.
(4) Lubricate the bore with a minimal amount of the lubricant that is being sealed.
(5) Torque for the two bolts ... 475 ± 50 N·m (350 ± 37 lb ft)
(6) Apply 5P-3413 Pipe Sealant to threads of drain assembly.
(7) Torque for the plug of the drain assembly ... 100 ± 10 N·m (75 ± 7 lb ft)
Note: Use 4C-8563 Drain Adapter in order to open the drain valve.
Note: Refer to the Disassembly and Assembly manual for instructions to set the preload for the input shaft bearings for the machine being serviced.
 | |
| Illustration 5 | g01430417 |
View F-F | |
(9) Torque for four studs ... 65 ± 10 N·m (48 ± 7 lb ft)
Note: Apply 9S-3263 Thread Lock Compound to the threads before installing studs (9) .
(10) Lubricate the bore with a minimal amount of the lubricant that is being sealed.
(A) Height of four studs ... 26 mm (1.02 inch)