C18 Marine and Marine Generator Set Engines Caterpillar


Engine Oil Pan

Usage:

C18 C1J


图 1g02536916
俯视图

表 1
技术规格,用于 228-0880 油底壳总成 
项目  数量  零件  技术规格说明 
353-5065 油底壳密封垫  在油底壳密封垫顶部沿整个接合长度涂覆超蓝 Loctite 587,如图 1 所示。 
8T-6761 管道螺塞  拧紧至扭矩为 82 ± 10 N·m (60 ± 7 lb ft)。 
9X-6451 排放塞  拧紧至扭矩为 70 ± 15 N·m (50 ± 11 lb ft)。 


图 2g02568454

表 2
技术规格,用于 228-0880 油底壳总成 
项目  数量  零件  技术规格说明 
    装配发动机油底壳时,使用下述步骤: 
    注:油底壳的密封面应没有机油、碎屑、密封垫材料或任何其他密封胶。 
    注:油底壳必须在涂覆密封胶后的 10 分钟内组装并紧固至缸体。 
    1. 涂抹 3 to 5 mm (0.1 to 0.2 inch) 的超蓝 Loctite 587 至以下位置:
前壳体和缸体前部的连接点。
飞轮壳和缸体后部的连接点。 
    2. 按图 2 至 40 ± 5 N·m (30 ± 4 lb ft) 中所示数字顺序拧紧螺栓 1 至螺栓 40。 
    2. 按图 2 至 47 ± 5 N·m (35 ± 4 lb ft) 中所示数字顺序再次拧紧螺栓 1 至螺栓 40。 

Caterpillar Information System:

C9 Industrial Engines Valve Mechanism Cover
CX31 On-Highway Transmission Power Train Pressures
C27 and C32 Engines for Caterpillar Built Machines Cylinder Head Valves
G3500 A3 Engines Air/Fuel Ratio Control - Oxygen Feedback
2006/02/20 Installation of a Spring in the Oil Filter Bypass Valve on Certain Applications {1306}
G3500 A3 Engines Carburetor
G3500 A3 Engines Location of Components
2006/03/13 The Heater and Air Conditioner Fan Motor has been Enhanced to Improve Motor Life {5927, 7304, 7320}
C18 Marine and Marine Generator Set Engines Engine Oil Filter Base
Update of Parameters for Throttle Inputs During Commissioning Procedure{1901, 4490} Update of Parameters for Throttle Inputs During Commissioning Procedure{1901, 4490}
C175 Generator Sets Fuel System Secondary Filter - Replace
G3500 A3 Engines Ignition System
2006/04/03 Spanner Wrench is Available for Servicing the Air Starting Motor {0700, 0710, 1451}
Installation Instructions for New Variable Valve Actuator (VVA) Pressure Sensor{5078, 5078} Installation Instructions for New Variable Valve Actuator (VVA) Pressure Sensor{5078, 5078}
C175 Generator Sets Speed Sensor - Clean/Inspect
C18 Marine and Marine Generator Set Engines Auxiliary Water Pump
CX31 On-Highway Transmission Transmission Oil Supply
2006/03/13 A New Piston and Rod Gp has been Released {1225}
2006/03/06 A Piston Ring Compressor is Available for C175 Engines {0701, 0705, 1215}
Installation of Speed Sensor Group{1907} Installation of Speed Sensor Group{1907}
2006/03/27 New Infrared Thermometer Has Narrow, 50:1 Target Ratio, Wide Temperature Range {0776, 1350, 3000, 4000, 4150, 4250}
TH31-E61 and TH35-E81 Petroleum Transmissions Plate Locations and Film Locations
TH31-C9I, TH31-C9P, TH31-C9T, TH35-C11I, TH35-C13I, TH35-C13T, TH35-C15I and TH35-C15T Petroleum Power Train Packages and TH31-E61 and TH35-E81 Petroleum Transmissions Power Train Electronic Control System Electronic Control Unit
CX31 On-Highway Transmission Retarder - Test
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.