Engine Oil Filter Base
Show/hide table
Illustration 1 | g01343097 |
(1) Base assembly
- Apply 154-9731 Thread Lock Compound on the tapered end of the hollow stud to length (D) . ... 10.2 ± 1.5 mm (0.40 ± 0.06 inch)
- Torque for hollow stud (4) ... 80 ± 14 N·m (60 ± 10 lb ft)
(2) Torque for taperlock studs ... 37 ± 5 N·m (27 ± 4 lb ft)
(3) Put clean engine oil on the filter seal. Tighten the filter until the seal contacts the base. After the seal contacts the base, rotate the filter by 180 degrees.
(5) Lightly lubricate the bore of the O-ring seal with the lubricant that is being sealed.
(6) 4N-8150 Spring
- Length under test force ... 55.24 mm (2.175 inch)
- Test force ... 75.619 ± 5.8 N (17 ± 1.3 lb)
- Free length after test ... 93.726 mm (3.6900 inch)
- Outside diameter ... 20.6 mm (0.81 inch)
- Test force ... 75.619 ± 5.8 N (17 ± 1.3 lb)
(7) The filter bypass valve must open at the following pressure difference. ... 255 ± 21 kPa (37 ± 3.0 psi)
Caterpillar Information System:
3508, 3512, and 3516 Generator Sets Cooling System Coolant Extender (ELC) - Add
G3500 A3 Engines Engine Monitoring System
3512 Industrial Engine Lubrication System Operation
G3500 A3 Engines Engine Governing
3500 Engines Exhaust Manifold - Remove and Install
3512C and 3516C Engines Flash Programming
C9 Marine Engines and C9 Marine Generator Sets Camshaft
3512 Industrial Engine Valve Lash and Valve Bridge Adjustment
3500 Engines Exhaust Manifold - Remove and Install
3500 Spark Ignited Engines Engine Design
3500 Spark Ignited Engines Engine Design
3512 Industrial Engine Valve Lash Check
3508, 3512, and 3516 Generator Sets Cooling System Coolant (ELC) - Change
3508, 3512, and 3516 Generator Sets Cooling System Coolant Level - Check
C15 On-Highway Engine Water Temperature Regulator
C15 Petroleum Generator Set Engines Engine Oil Pressure Sensor
C15 Petroleum Engine Engine Oil Level - Check
C175 Generator Sets Crankshaft Vibration Damper - Inspect
3516 Generator Set Engine Fuel Injector
C4.4 (Mech) Industrial Engine Alternator Belt - Inspect/Adjust/Replace - Poly V-Belt
C280 Marine Auxiliary Engines Electrical Connectors and Functions
C175 Generator Sets Engine Crankcase Breather - Clean
C11 and C13 Industrial Engines Safety Messages
G3500 A3 Engines Engine Sensors