Required Tools | |||
---|---|---|---|
Tool | Part Number | Part Description | Qty |
A | FT-1114 | Vacuum Cap | 1 |
5P-0306 | Vacuum Transducer | 1 | |
6V-4142 | Fitting | 1 | |
5K-5068 | Fitting | 1 |
Start By:
- Release the hydraulic system pressure. Refer to Disassembly and Assembly, "System Pressure - Release".
Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products. Dispose of all fluids according to local regulations and mandates. |
- Install Tooling (A) onto the hydraulic tank. Attach an air supply hose onto Tooling (A). Apply
276 to 414 kPa (40 to 60 psi) of air. This procedure will pull vacuum on the hydraulic system.Show/hide tableIllustration 2 g01266153 - Remove guard (1).
Show/hide table
Illustration 3 g01266154 - Remove accumulator (2).
Illustration 1 | g01266584 |
Required Tools | |||
---|---|---|---|
Tool | Part Number | Part Description | Qty |
A | FT-1114 | Vacuum Cap | 1 |
5P-0306 | Vacuum Transducer | 1 | |
6V-4142 | Fitting | 1 | |
5K-5068 | Fitting | 1 |
Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.
- Install accumulator (2).
Show/hide table
Illustration 5 g01266153 - Install guard (1).
Show/hide table
Illustration 6 g01266584 - Remove Tooling (A) from the hydraulic tank.
Illustration 4 | g01266154 |