C11 and C13 Engines Caterpillar


Electric Starting Motor

Usage:

730C2 2L7



图 1g01219226

当从驱动端观看电起动马达时,马达旋转方向如下。 ... 顺时针

25 °C (77 °F) 时无负载

无负载时最小速度 ... 7643 ± 1683 rpm
无负荷时最大电流 ... 76.5 ± 14.5 安培
电压 ... 23 V

(1) 蓄电池终端

螺母之间应最多有三条电缆或电线端子。
将蓄电池端子上的螺母拧紧至以下扭矩。 ... 30.5 ± 3.5 N·m (22 ± 3 lb ft)

(2) 接地端子

将接地端子上的螺母拧紧至以下扭矩。 ... 30.5 ± 3.5 N·m (22 ± 3 lb ft)

(3) 接地端子

将接地端子上的螺母拧紧至以下扭矩。 ... 2.25 ± 0.25 N·m (20 ± 2 lb in)

(4) 开关端子

开关端子上的电线端子必须用热收缩管隔离。 不要使用模压端子。
将开关端子上的螺母上紧到以下扭矩。 ... 2.25 ± 0.25 N·m (20 ± 2 lb in)

(5) 马达终端

将马达端子上的螺母拧紧到以下扭矩。 ... 30.5 ± 3.5 N·m (22 ± 3 lb ft)

(6) 马达机架终端

将马达机架端子上的螺母拧紧至下列扭矩。 ... 8 ± 3 N·m (70 ± 27 lb in)

电磁阀

在 20 V 和 25 °C ( 77 °F) 下的最大电流

吸合绕组 ... 57 A
保持绕组 ... 最大值 16 安培

Caterpillar Information System:

C11 and C13 Engines Alternator and Regulator
C13 and C15 On-highway Engines Idle Speed Is High
C27 and C32 Generator Set Engines Engine Oil Pump - Install
3500 Engines Customer Parameters Worksheet
C27 and C32 Generator Set Engines Engine Oil Pump - Assemble
3500 Engines Electrical Connectors and Functions
C27 and C32 Generator Set Engines Engine Oil Pump - Disassemble
C175 Generator Set Engines Fuel Filter Housing - Install
Caterpillar On-Highway Diesel Engine Fluids Recommendations Lubricant Viscosities
C9.3 Engine for Caterpillar Built Machines Air Inlet Heater
C6.6 Generator Sets Safety Messages
C27 and C32 Generator Set Engines Engine Oil Pump - Remove
C15 and C18 Industrial Engines Fuel Filter Base
C27 and C32 Generator Set Engines Water Pump - Remove
C27 and C32 Generator Set Engines Water Pump - Install
320D Excavator Machine Systems Swing Gear and Bearing - Install
C15 and C18 Industrial Engines Fuel Filter and Water Separator
C27 and C32 Generator Set Engines Water Temperature Regulator Housing - Remove and Install
TH48-E80 Petroleum Transmission Power Train Electrical System
C27 and C32 Generator Set Engines Gear Group (Rear) - Remove
C7 Engine for 584 and 584HD Forwarders and for 525C, 535C, and 545C Wheel Skidders CID 0091 FMI 08 Throttle Position signal abnormal
Hydraulic Gear Pumps Used in Transmissions {3066, 5073} Hydraulic Gear Pumps Used in Transmissions {3066, 5073}
2005/12/12 Improved Engine Dipsticks are Now Used {1326}
C11 and C13 Industrial Engines Monitoring System
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.