Required Tools | |||
---|---|---|---|
Tool | Part Number | Part Description | Qty |
A | 138-7575 | Link Bracket | 2 |
ZZ | 179-4453 | Protective Cap | 5 |
2J-2668 | Cover | 5 | |
8S-4950 | Cap | 2 | |
9S-8927 | Plug | 2 |
Start By:
- Connect the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".
Note: SERVICE DATA: TOOLING (ZZ) WILL NOT BE IDENTIFIED IN PHOTOGRAPHS IN THE REMOVAL OR THE INSTALLATION. THIS TOOLING IS SHOWN IN ORDER TO ASSIST THE EXPERIENCED SERVICEMAN.
Note: Put identification marks on all lines, on all hoses and on all tubes for installation purposes. Plug all lines, all hoses and all tubes. This will help to prevent fluid loss and this will help to keep contaminants from entering the system.
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products. Dispose of all fluids according to local regulations and mandates. |
Hot oil and components can cause personal injury. Do not allow hot oil or components to contact skin. |
- Disconnect hose assemblies (2), (3), (4), and (5) from steering control valve (1).
Show/hide table
Illustration 2 g01092189 - Disconnect hose assemblies (6) and (8).
- Remove the O-ring seal from manifold (7). Position manifold (7) and hose assembly (9) out of the way.
Show/hide table
Illustration 3 g01092190 - Install Tooling (A) and a suitable lifting device to steering control valve (1). The weight of the steering control valve is approximately
45 kg (98 lb) . Remove three bolts (10) and steering control valve (1).
Illustration 1 | g01092188 |