Flywheel Housing
Show/hide table
Illustration 1 | g00820369 |
(1) Back plate
(2) Flywheel housing
(3) Tighten the setscrews for the back plate to the following torque. ...
(4) Crankshaft rear seal
(5) Tighten the setscrews for the flywheel housing to the following torque. ...
Caterpillar Information System:
3500 Engines Fuel Filter Restriction
C32 Petroleum Generator Sets Engine Crankcase Breather - Clean
C18 Generator Set Manual Stop Procedure - EMCP 3 (If Equipped)
C32 Petroleum Engines Plate Locations and Film Locations
C15 and C18 Petroleum Generator Sets Starting the Engine - EMCP 3
3500 Engines Engine Overspeed
3500 Engines Coolant Temperature Is Too Low
3500 Engines Crankcase Pressure (High)
C2.2 Engine and C1.5 Generator Set Gear Group (Front)
C2.2 Engine and C1.5 Generator Set General Information
C2.2 Engine and C1.5 Generator Set Piston and Rings
C9 Generator Set Self-Diagnostics - If Equipped with EMCP 3
C2.2 Engine and C1.5 Generator Set Crankshaft Pulley
C2.2 Engine and C1.5 Generator Set Alternator and Regulator
C2.2 Engine and C1.5 Generator Set Electric Starting Motor
C2.2 Engine and C1.5 Generator Set Air Inlet and Exhaust System
C2.2 Engine and C1.5 Generator Set Engine Oil Pressure Switch
C2.2 Engine and C1.5 Generator Set Lubrication System
C2.2 Engine and C1.5 Generator Set Glow Plugs
C2.2 Engine and C1.5 Generator Set Cooling System
C2.2 Engine and C1.5 Generator Set Basic Engine
C6.6 Industrial Engine Reference Material
C2.2 Engine and C1.5 Generator Set Troubleshooting
C2.2 Engine and C1.5 Generator Set Fuel Injection Timing - Check