Engine Oil Filter Base
One-Piece Body
Show/hide table
Illustration 1 | g01160885 |
(1) 242-3864 Spring
- Quantity ... 2
- Length under test force ... 43.18 mm (1.70 inch)
- Test force ... 43.7 N (9.8 lb)
- Free length after test ... 58.50 ± 0.50 mm (2.303 ± 0.020 inch)
- Outside diameter ... 11.0 mm (0.43 inch)
- Length under test force ... 43.18 mm (1.70 inch)
(2) The bypass valves must open at the following pressure. ... 125 ± 30 kPa (18.0 ± 4.5 psi)
Show/hide table
Illustration 2 | g01522556 |
Torque sequence for the oil filter base |
Show/hide table
Illustration 3 | g01522581 |
Section A-A |
(B) Length for applying 154-9731 Thread Lock Compound on the tapered end of the stud ... 7.5 ± 1.5 mm (0.30 ± 0.06 inch)
(3) Torque for the stud ... 68 ± 7 N·m (50 ± 5 lb ft)
Use the following procedure in order to tighten the bolts for the oil filter base:
- Tighten the bolts to the sequence that is shown in the Illustration 2 to 15 N·m (11 lb ft).
- Again tighten the bolts to the sequence that is shown in the Illustration 2 to 28 N·m (21 lb ft).
Caterpillar Information System:
TH48-E80 Petroleum Transmission Torque Converter and Transmission Oil Level - Check
TH48-E80 Petroleum Transmission Breather (Transmission) - Clean
C4.4 Industrial Engine Starting the Engine
2005/05/23 New ROPS Films, FOPS Films and TOPS Films Have Been Designed {7557}
C7 On-highway Engine Exhaust Manifold
3054C and C4.4 Industrial Engine and Marine Auxiliary Engine Electric Starting Motor
3054C and C4.4 Industrial Engine and Marine Auxiliary Engine Electric Starting Motor
C7 On-highway Engine Engine Control Module
C4.4 Marine Generator Set Engines Fuel Injection Pump - Remove
C3.3 and C4.4 Generator Sets Fuel Injection Nozzles - Install
C4.4 (Mech) Marine Generator Set MCS-3 Magnetic Pickup
C280 Marine Propulsion Engines Low Power/Poor or No Response to Throttle
2005/09/26 New Fuel Transfer Pump {1256}
C9.3 Tier 4 Final Engines Front Housing and Covers
Reuse and Salvage for 3176, 3300, 3400 & C-Series Engine Cylinder Blocks {0670, 0672, 0761, 1201, 7225} Reuse and Salvage for 3176, 3300, 3400 & C-Series Engine Cylinder Blocks {0670, 0672, 0761, 1201, 7225}
325D and 329D Excavators Storage and Literature Compartment - If Equipped
C280 Marine Auxiliary Engines Noise Coming from Cylinder
C280 Marine Propulsion Engines Poor Fuel Consumption
3500 Engines Coolant Temperature Is Too High
TH48-E80 Petroleum Transmission Torque Converter and Transmission Oil - Change
C1.5 GEN SET Electric Power Generation Fuel System Primary Filter/Water Separator - Drain
C7.1-XQ200 Rental Generator Set Walk-Around Inspection
C18 Generator Set Product Lifting
3054E Industrial Engine Balancer Group - Remove - If Equipped