TH48-E80 Petroleum Transmission Caterpillar


Torque Converter and Transmission Oil - Change

Usage:

TH48-E80 FRT

------ WARNING! ------

热油和热的部件可能会导致人员受伤。 不要让热的油和部件接触皮肤。



注意

在进行检验、保养、测试、调整及维修产品期间,必须小心以确保装好排放出的油液。 在打开任何舱室或解体任何储有液体的部件之前,要准备好合适的容器收集液体。

有关收集和盛接 Cat 产品上油液的适用工具和用品,请参阅专门出版物, NENG2500, "代理商维修工具目录"。

按照当地法规和要求处置所有液体。




    图 1g02935539
    左视图
    (1) 呼吸器盖
    (2) 目测表
    (3) 排放塞

  1. 取下通气孔盖 (1),防止从变速箱箱体排放机油时出现真空。

  2. 从变速箱底部拆下排放螺塞 (3)。 将机油排放到适当的容器中。

  3. 排放出变速箱壳体中的机油后,清洁排放塞 (3) 并安装排放塞 (3)。

  4. 向变速箱外壳加油。 参考操作和保养手册, "润滑剂粘度"和操作和保养手册, "再加注容量"。

  5. 确保变速箱处于空档位置。 盘车起动发动机 15 秒。 不要让发动机起动。

  6. 检查变速箱箱体侧面目测表 (2) 显示的油位。 重复步骤 4 至步骤 5,直到油位处在目测表 (2) "COLD(冷)"侧的 "ADD(添加)"标记和 "FULL(满)"标记之间。

  7. 安装通气孔盖 (1)。

  8. 起动发动机并在低怠速下运转。 检查有无泄漏并进行必要的修理。

  9. 当油温热和变速箱在空档位置时,观察油位。

  10. 将油位保持在目测表 (2) "HOT(热)"侧的 "ADD(添加)"标记和 "FULL(满)"标记之间。

  11. 必要时停止发动机并加油。


注意

换油后,不正确加注变速箱油箱可能引起变速箱离合器的损坏。 遵照上面描述的程序。

变速箱方向和速度操纵杆必须保留在空档(NEUTRAL),直到系统充满。


Caterpillar Information System:

3500 Engines Coolant Temperature Is Too High
C280 Marine Propulsion Engines Poor Fuel Consumption
C280 Marine Auxiliary Engines Noise Coming from Cylinder
325D and 329D Excavators Storage and Literature Compartment - If Equipped
Reuse and Salvage for 3176, 3300, 3400 & C-Series Engine Cylinder Blocks {0670, 0672, 0761, 1201, 7225} Reuse and Salvage for 3176, 3300, 3400 & C-Series Engine Cylinder Blocks {0670, 0672, 0761, 1201, 7225}
C9.3 Tier 4 Final Engines Front Housing and Covers
2005/09/26 New Fuel Transfer Pump {1256}
C7 On-highway Engine Engine Oil Filter Base
TH48-E80 Petroleum Transmission Torque Converter and Transmission Oil Level - Check
TH48-E80 Petroleum Transmission Breather (Transmission) - Clean
C4.4 Industrial Engine Starting the Engine
2005/05/23 New ROPS Films, FOPS Films and TOPS Films Have Been Designed {7557}
C1.5 GEN SET Electric Power Generation Fuel System Primary Filter/Water Separator - Drain
C7.1-XQ200 Rental Generator Set Walk-Around Inspection
C18 Generator Set Product Lifting
3054E Industrial Engine Balancer Group - Remove - If Equipped
Caterpillar 270 Air Compressor Specification
TH48-E70 Petroleum Transmission Torque Converter and Transmission Oil Sample - Obtain
3500B and 3500C Generator Set Engines Air Shutoff System
C27 PET GEN SET Electric Power Generation and C27 KNOCKDOWN K Petroleum Power Train Package Parallel Operation
345C and W345C Excavators and 345C MHPU Mobile Hydraulic Power Unit Machine Electronic Control System Calibration
C4.4 Marine Auxiliary Generator Set Engine Coolant Temperature Sender
C4.4 (Mech) Marine Generator Set MCS-3 Coolant Temperature Switch
Caterpillar 270 Air Compressor Air Induction
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.