Fuel Injection Nozzles - Install
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Apply clean engine oil to new seat washer (6). Install the new seat washer in the cylinder head.
Note: If the original seat washer is reused, the projection of the fuel injection nozzle will be incorrect.
- Install O-ring seal (5) on fuel injection nozzle (1). Install the fuel injection nozzle in the cylinder head.
Note: Alignment Pin (X) must be located opposite clamp (4).
- Position clamps (4) on fuel injection nozzles (1). Install bolts (3). Tighten the bolts to a torque of
35 N·m (26 lb ft) . - Install hoses (2) on fuel injection nozzles (1).
Show/hide table
Illustration 1 | g01160583 |
Typical example |
End By:
- Install the fuel injection lines. Refer to Disassembly and Assembly, "Fuel Injection Lines - Remove and Install".
Caterpillar Information System:
C4.4 (Mech) Marine Generator Set MCS-3 Magnetic Pickup
C280 Marine Propulsion Engines Low Power/Poor or No Response to Throttle
C4.4 Marine Auxiliary Generator Set Engine Glow Plugs
C4.4 Marine Auxiliary Generator Set Engine Aftercooler
320D, 321D, 323D, 324D, 325D, 326D, 328D, 329D, 330D, 336D, 336D2, 340D and 340D2 Excavators, 324D Forest Machine and 323D MHPU, 324D MHPU, 325D MHPU, 329D MHPU, 330D MHPU and 336D MHPU Mobile Hydraulic Power Units Machine Electronic Control System Using Caterpillar Electronic Technician to Determine Diagnostic Codes
C3.3 and C4.4 Generator Sets Fuel Injection Nozzles - Remove
2005/09/26 New Fuel Transfer Pump {1256}
C4.4 Marine Generator Set Engines Fuel Injection Lines - Remove and Install
3500 Engines Low Engine Oil Pressure
2005/04/18 Replace the Gear when the Sleeve Bearing is Replaced {1212, 1234}
C2.2 Generator Sets Reference Material
C18 Marine Generator Set Voltage Connections
C4.4 Marine Generator Set Engines Fuel Injection Pump - Remove
C7 On-highway Engine Engine Control Module
3054C and C4.4 Industrial Engine and Marine Auxiliary Engine Electric Starting Motor
3054C and C4.4 Industrial Engine and Marine Auxiliary Engine Electric Starting Motor
C7 On-highway Engine Exhaust Manifold
2005/05/23 New ROPS Films, FOPS Films and TOPS Films Have Been Designed {7557}
C4.4 Industrial Engine Starting the Engine
TH48-E80 Petroleum Transmission Breather (Transmission) - Clean
TH48-E80 Petroleum Transmission Torque Converter and Transmission Oil Level - Check
C7 On-highway Engine Engine Oil Filter Base
2005/09/26 New Fuel Transfer Pump {1256}
C9.3 Tier 4 Final Engines Front Housing and Covers