Customer Parameters Worksheet
The Electronic Ignition System (EIS) can support many different types of engines and applications. This is achieved by programming the values of certain parameters into the system's modules.
Use Illustration 1 in order to record the values of the parameters for the EIS control module.
Note: If the parameters cannot be read from a module, the parameters must be obtained from records or from the factory.
Show/hide table
 | |
| Illustration 1 | g01155562 |
Caterpillar Information System:
3500 Engines for Caterpillar Built Generator Sets Vibration Damper
3512C Engine Overhaul (Top End)
3512C Engine Overhaul (Major)
C9 Generator Set Engines Fuel Priming Pump
C280-16 Petroleum Engine Manual Valve Group (Cylinder Pressure)
C7 Engines for Caterpillar Built Machines Fan Drive Mounting Group
C27 and C32 Engines for Caterpillar Built Machines Engine Oil Pressure Sensor
C1.5 GEN SET Electric Power Generation Control Panel
G3400 Engines (EIS) Programming Parameters
C280 Marine and Petroleum Engines Camshaft Bearing Position
C280 Marine and Petroleum Engines Camshaft Bearing Position
C280 Marine and Petroleum Engines Camshaft
C27 and C32 Industrial and Petroleum Engines Electronic Control System Components
G3400 Engines (EIS) Replacing the EIS Control Module
C27 and C32 Industrial and Petroleum Engines Fuel System
C27 and C32 Industrial and Petroleum Engines Air Inlet and Exhaust System
C4.4 Marine Generator Set Engine Oil and Filter - Change
G3400 Engines (EIS) Troubleshooting Data Sheet
C27 and C32 Industrial and Petroleum Engines Cooling System
XQ125 Generator Set Alternator and Fan Belts - Replace
G3400 Engines (EIS) Detonation
C9 Engines for Caterpillar Built Machines Water Pump - Disassemble
C12 Marine Engine Cooling System
2005/03/28 A New Fuel Shield is Available {1252}