Ejector Support Rollers - Check/Adjust
Park the machine on level ground. Lower the bowl and close the apron.
The ejector support rollers are located at the rear of the ejector. There are 2 ejector support rollers. These rollers support the rear portion of the ejector. The rollers run in a track (3) . A track is located on each side of the frame for the ejector.
Show/hide table
 | |
| Illustration 1 | g00435120 |
Check the adjustment for the ejector support rollers. Measure the clearance between the roller (1) and the inside wall of the track. The clearance should be between 0.8 mm (.03 inch) and 3.3 mm (.13 inch). Shims will need to be used to establish the correct distance.
Refer to Disassembly and Assembly, SENR6809, "Ejector Support Rollers" for additional information.
Refer to Specifications, SENR6822, "Ejector Group" for additional information.
Caterpillar Information System:
992G Wheel Loader Machine Systems Piston Pump (Variable Displacement) - Remove
IT14G Integrated Toolcarrier and 914G Wheel Loader Machine Systems Tilt Cylinder - Remove
966G Wheel Loader and 972G Wheel Loader Power Train Transmission Hydraulic Control
992G Wheel Loader and 854G Wheel Dozer Braking System Service Brake System Pressure - Test
992G Wheel Loader Machine Systems Piston Pump (Fixed Displacement) - Install
966G Wheel Loader and 972G Wheel Loader Power Train Oil Filter (Power Train)
902 and 906 Compact Wheel Loaders Power Train System Hydrostatic System
992G Wheel Loader and 854G Wheel Dozer Braking System Parking Brake Control Cable - Adjust
IT14G Integrated Toolcarrier and 914G Wheel Loader Braking System Service Brake System Pressure - Test
992G Wheel Loader and 854G Wheel Dozer Braking System Limit Switch (Parking Brake) - Check
623F Wheel Tractor-Scraper Ejector Guide Rollers - Inspect/Lubricate/Replace
992G Wheel Loader and 854G Wheel Dozer Braking System Brake System Air - Purge
966G Wheel Loader and 972G Wheel Loader Power Train Transmission Hydraulic Control Operation
613C Series II Wheel Tractor Power Train Axle Housing - Remove
613C Series II Wheel Tractor Power Train Axle Housing - Install
613C Series II Wheel Tractor Power Train Axle Shaft - Remove
613C Series II Wheel Tractor Power Train Axle Shaft - Install
3512 Industrial Engine Engine Operation with Active Diagnostic Codes
623F Wheel Tractor-Scraper Ejector Support Rollers - Inspect/Pack/Replace
992G Wheel Loader Machine Systems Piston Pump (Variable Displacement) - Install
992G Wheel Loader and 854G Wheel Dozer Braking System Service Brakes - Test
992G Wheel Loader and 854G Wheel Dozer Braking System Parking Brake - Test
D9R Track-Type Tractor Cab Door
631E Series II Wheel Tractor-Scrapers Fuses - Replace