Gear Group (Front)
Show/hide table
Illustration 1 | g00988013 |
(1) Camshaft gear
(2) Idler gear
-
End play of idler gear
- Standard at assembly ... 0.05 to 0.20 mm (0.0020 to 0.0079 inch)
- Service limit ... 0.35 mm (0.0138 inch)
Clearance between idler gear bushing and shaft
- Standard at assembly ... 0.009 to 0.050 mm (0.0004 to 0.0020 inch)
- Service limit ... 0.100 mm (0.0039 inch)
(3) Fuel Injection pump gear
-
Tighten the bolts for the fuel injection pump gear to the following torque.
- Naturally aspirated engines ... 59 to 69 N·m (43 to 51 lb ft)
- Turbocharged engines ... 83 to 98 N·m (62 to 72 lb ft)
(4) Crankshaft gear
(5) Oil pump gear
(6) Tighten the thrust plate bolts for the idler gear to the following torque. ... 29 to 39 N·m (21 to 29 lb ft)
(7) Tighten the jam nut for the oil pump gear to the following torque. ... 28 to 38 N·m (21 to 28 lb ft)
Backlash for all gears
- Standard at assembly ... 0.03 to 0.18 mm (0.0012 to 0.0071 inch)
- Service Limit ... 0.25 mm (0.0098 inch)
Caterpillar Information System:
3044C Industrial Engine and Engines for Caterpillar Built Machines Front Housing and Covers
2003/04/01 The Procedure for Shipping Service Manuals has Changed {0374}
3044C Industrial Engine and Engines for Caterpillar Built Machines Piston and Rings
3044C Industrial Engine Emergency Stopping
3612 and 3616 Engines Fuel Pressure Control Valve - Front Mounted Turbocharger
3044C Industrial Engine Stopping the Engine
3044C Industrial Engine and Engines for Caterpillar Built Machines Connecting Rod
3044C Industrial Engine Engine Description
Cat Gas Engine Lubricant, Fuel, and Coolant Recommendations Supplemental Coolant Additive (SCA)
G3500B Engines Alternator Wiring
3044C Industrial Engine and Engines for Caterpillar Built Machines Engine Valve Lash - Inspect/Adjust
3044C Industrial Engine Turbocharger - Inspect - If Equipped
UPS 250, UPS 300, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supply Parallel Cabinet Controller Board - Remove and Install
UPS 250, UPS 300, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supply Zig Zag Controller Board - Remove and Install
UPS 250, UPS 300, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supply System Input/Output Daughter Board - Remove and Install
3044C Industrial Engine and Engines for Caterpillar Built Machines Flywheel
3044C Industrial Engine and Engines for Caterpillar Built Machines Crankshaft Pulley
3034 Engine for Caterpillar Built Machines Crankshaft Main Bearings - Install
C4.4 (Mech) Industrial Engine Valve Guide - Inspect
3034 Engine for Caterpillar Built Machines Crankshaft Main Bearings - Remove
3044C Industrial Engine Engine Oil Level - Check
3044C Industrial Engine Cooling System Coolant Level - Check
G3500B Engines Ignition System - 20 Cylinders
3044C Industrial Engine Reference Material