Camshaft Gear - Remove and Install
拆卸步骤
Show/hide table
所需工具     | |||
工具     | 零件号     | 零件名称     | 数量     |
A     | 230-6284     | 正时销 (凸轮轴)     | 1     |
B     | 230-6283     | 正时销 (曲轴)     | 1     |
开始:
- 拆下风扇。 请参阅拆解和组装, "风扇 - 拆卸和安装"。
- 拆下前盖。 请参阅拆解和组装, "前盖 - 拆卸和安装"。
- 拆下惰轮。 请参阅拆解和组装, "惰齿轮 - 拆卸和安装"。
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 从凸轮轴齿轮 (2) 上拆下调整螺钉 (1) 和垫圈。
Show/hide table
图 1 | g01001848 |
- 从凸轮轴上拆下凸轮轴齿轮。
注: 不要丢失凸轮轴齿轮的键。
安装步骤
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 确保 1 号气缸处于压缩冲程的上止点。 请参阅测试和调整, "找到 1 号活塞上止点位置"。
- 检查凸轮轴齿轮和键有无磨损或损坏。
- 穿过凸轮轴齿轮安装工具 (A) 。 将工具 (B) 安装在曲柄臂内。
- 将凸轮轴齿轮 (2) 安装到凸轮轴上。
注: 确保已安装凸轮轴的键。 安装凸轮轴齿轮时,确保带标记的轮齿朝向前方。 如有必要,用软锤轻敲齿轮将键座入键槽内。 确保工具 (A) 进入前壳体的孔中。
Show/hide table
图 2 | g01001848 |
- 将调整螺钉 (1) 和垫圈安装到凸轮轴齿轮 (2) 上。 将调整螺钉拧紧至扭矩 95 N·m (70 lb ft)。
- 从凸轮轴齿轮上拆下工具 (A) 。 从曲柄臂上拆下工具 (B) 。
End By:
- 安装惰齿轮。 请参阅 拆解和组装, "惰齿轮 - 拆卸和安装"。
- 安装前盖。 请参阅 拆解和组装, "前盖 - 拆卸和安装"。
- 安装风扇。 请参阅 拆解和组装, "风扇 - 拆卸和安装"。
Caterpillar Information System:
C11, C13 and C15 On-highway Engines 0166-14 Rated Engine Power Special Instructions
C15 On-Highway Engines Electronic Control System Components
3056E Industrial Engine Connecting Rod - Inspect
3056E Industrial Engine Belt Tension Chart
3056E Industrial Engine Vibration Damper - Check
C11, C13 and C15 On-highway Engines Cooling Fan Circuit and A/C High Pressure Switch Circuit - Test
G3306 Engine Cooling System Coolant Sample (Level 2) - Obtain
G3306 Engine Cooling System Coolant Sample (Level 1) - Obtain
320C U Excavator Hydraulic System Oil Sample - Obtain
C9 Marine Engines Engine Cranks but Will Not Start
G3520B Engines MID 033 - CID 0168 - FMI 02 System Voltage intermittent/erratic
322B L and 325B L Excavators, 322B and 325B Forest Machines and 325B Material Handler Swing Drive Oil Sample - Obtain
C15 On-Highway Engines Air Inlet and Exhaust System
C11 and C13 Engines for Caterpillar Built Machines Basic Engine
C9 Marine Engines Low Power/Poor or No Response to Throttle
3054C Industrial Engine Idler Gear - Remove and Install - Delphi DP210 Fuel Injection Pump
C15 On-Highway Engines Basic Engine
3054C Industrial Engine Housing (Front) - Remove
3126B Marine Engines E015 High Engine Coolant Temperature Derate
3126B Marine Engines E017 High Engine Coolant Temperature Warning
3512B and 3516B Engines Air Lines
3126B Marine Engines E039 Low Engine Oil Pressure Derate
C18 Marine and Marine Generator Set Engines Cylinder Head
C9 Marine Engines E190 Engine Overspeed Warning