Corrections to Disassembly and Assembly, RENR1333, "3618 Engine" , "Piston and Connecting Rods - Install" {1225}
- Engine:
- 3618 (S/N: 2MW1-UP)
Inside Step 23, the clearance measurement is incorrect. The correct Step 23 follows:
- Use Tooling (D) to measure the clearance at the sides of the connecting rod on the crankshaft. Place a pry bar between the connecting rod and the counterweight or the main bearing cap. Carefully move the connecting rod. The correct clearance is 0.58 to 1.42 mm (0.023 to 0.056 inch).
If the clearance is not correct, remove the connecting rod cap. Make sure that the cap is on the correct connecting rod. Inspect the components for wear and/or damage.
Show/hide table
 | |
| Illustration 1 | g00574740 |
Typical example | |
Caterpillar Information System:
C1.5 and C2.2 Engines For Caterpillar Built Marine Generator Sets Cooling System
C1.5 and C2.2 Engines For Caterpillar Built Marine Generator Sets Lubrication System
C1.5 and C2.2 Engines For Caterpillar Built Marine Generator Sets Air Inlet and Exhaust System
797B Off-Highway Truck Hydraulic System Operational Checks
Cold Weather Recommendations for All Caterpillar Machines Before Starting Engine
797 Off-Highway Truck Hydraulic System Visual Inspection
3406E, C-10 and C-12 On-highway Engines 0084-10 Vehicle Speed signal rate of change (36)
3406E, C-10 and C-12 On-highway Engines 0084-08 Vehicle Speed signal out of range (36)
3406E, C-10 and C-12 On-highway Engines 0084-14 Quick Stop Occurrence
3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines 0084-02 Vehicle Speed signal invalid (36)
797 Off-Highway Truck Hydraulic System Machine Preparation for Troubleshooting
C13 Engine for Combat and Tactical Vehicles Lubrication System
C9 Urban Transit Bus Engine Exhaust Temperature - Test
2003/02/01 Tone Change for the New Heavy Duty 10-02 Engines {0116, 1000}
3126B and 3126E On-highway Engines 0091-08 Throttle Position Invalid (32)
3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines 0091-13 Throttle Position out of calibration (28)
3406E, C-10 and C-12 On-highway Engines 0174-00 High Fuel Temperature Warning (65)
G3520B Engines MID 033 - CID 0401 - FMI 05 Ignition Transformer Secondary #1 open circuit
3412E Petroleum Engine CID 0094 FMI 04 Fuel Pressure short to ground
G3520B Engines MID 033 - CID 0401 - FMI 06 Ignition Transformer Secondary #1 short to ground
G3520B Engines MID 033 - CID 0403 - FMI 05 Ignition Transformer Secondary #3 open circuit
G3520B Engines MID 033 - CID 0403 - FMI 06 Ignition Transformer Secondary #3 short to ground
G3520B Engines MID 033 - CID 0405 - FMI 05 Ignition Transformer Secondary #5 open circuit
G3520B Engines MID 033 - CID 0405 - FMI 06 Ignition Transformer Secondary #5 short to ground