Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | 1P-1857 | Retaining Ring Pliers | 1 |
Start By:
- Remove the engine oil pan. Refer to Disassembly and Assembly, "Engine Oil Pan - Remove and Install".
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove bolts (8) that hold tube assembly (9) for engine oil relief valve (2).
Note: Tube assembly (9) is used when the engine oil filter is installed on the right side of the engine.
- Remove bolts (1). Remove engine oil bypass valve (2) from cylinder block (7).
Show/hide table
Personal injury can result from being struck by parts propelled by a released spring force.
Make sure to wear all necessary protective equipment.
Follow the recommended procedure and use all recommended tooling to release the spring force.
- Use Tooling (A) in order to remove retaining ring (6), seat (5), spring (4), and plunger (3) from the housing.
- Check the seat, the spring, the plunger, and the housing for wear or for other damage. The plunger (3) must slide easily in the housing.
Illustration 1 | g00941609 |
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | 1P-1857 | Retaining Ring Pliers | 1 |
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Clean the mating surfaces of the engine oil relief valve and the cylinder block.
- Clean the internal components of the engine oil relief valve. Lubricate the internal components of the engine oil relief valve with clean engine oil.
Show/hide table
Improper assembly of parts that are spring loaded can cause bodily injury.
To prevent possible injury, follow the established assembly procedure and wear protective equipment.
Show/hide tableIllustration 2 g00941609 - Install plunger (3), spring (4), and seat (5) in the housing. Apply pressure to seat (5) and install retaining ring (6) with Tooling (A).
- Install the engine oil bypass valve (2). Install bolts (1). Tighten bolts (1) to a torque of
22 N·m (16 lb ft) . - Install tube assembly (9) to engine oil bypass valve (2). Install bolts (8).
Note: Tube assembly (9) is used when the engine oil filter is installed on the right side of the engine.
End By:
- Install the engine oil pan. Refer to Disassembly and Assembly, "Engine Oil Pan - Remove and Install".