SR4BHV and SR4HV Electric Power Generation Connection Diagram - SR4 HV ; SR4B HV Caterpillar


Specific Connection Diagrams

Usage:

SR4 5HW
This book contains the connection diagrams for most of the variations of options that are possible on a particular generator set. The selection table and the following procedure should be used in order to determine the specific connection diagram that applies to the particular customer installed options on a generator set. From the selection table and the following procedure, a schematic code is obtained. This schematic code will identify the correct schematic to use.

Identifying the Schematic

  1. See the following selection table. Select one item from each section. Mark an X in the check box that corresponds to the particular options of the generator set that is being serviced.

  1. Transfer the section code for each marked check box of the selection table to the corresponding section in the section code table. This combination of numbers is now referred to as the schematic code. This schematic code identifies the correct schematic.

  1. Find the corresponding schematic code in this book. The code will be followed by the appropriate schematic.

Selection Table

Table 1
Selection Table    
    Check Box     Section Code    
Section A - Voltage Regulator    
    Automatic Voltage Regulator, KCR-760         1    
    Digital Voltage Regulator, DECS 125-15         2    
    Automatic Voltage Regulator, K65-12B (1 V/Hz)         3    
    Automatic Voltage Regulator, K65-12B (2 V/Hz)         4    
Section B - Automatic/Manual Voltage Control Modules    
    None         0    
    Automatic/Manual Voltage Control, MVC-300 (1)         1    
    Automatic/Manual Voltage Control, MVC-108 (1)         2    
    Automatic/Manual Voltage Control, MVC-112 (2)         3    
Section C - Motor Operated Potentiometer, MOC2    
    No         0    
    Yes         1    
Section D - Diode Fault Detector    
    No         0    
    Yes         1    
Section E - VAR/Power Factor Controller, SCP250    
    No         0    
    Yes (3)         1    
Section F - Excitation Limiter, EL200    
    No         0    
    Yes (3)         1    
( 1 ) Cannot be used with the Digital Excitation Control, DECS 125-15
( 2 ) Can only be used with the Digital Excitation Control, DECS 125-15, and the Automatic Voltage Regulator, K65-12B
( 3 ) Not required with the Digital Excitation Control, DECS 125-15

Table 2
Selection Code Table    
Section Letter     A     B     C     D     E     F    
Schematic Code                            

Caterpillar Information System:

SR4BHV and SR4HV Electric Power Generation Connection Diagram - SR4 HV ; SR4B HV Reference Information
3054E Industrial Engine Gear Group (Front)
3500 and 3500B High Displacement Engines for Caterpillar Built Machines Turbocharger - Disassemble
3054E Industrial Engine Front Housing and Covers
3524B Engine for Caterpillar Built Machines Fuel Transfer Pump - Assemble
C9 Engine For Caterpillar Built Machines Engine Oil Pump - Remove
C-15, C-16, and C-18 Engines Electric Starting System - Test
3500 and 3500B High Displacement Engines for Caterpillar Built Machines Air Inlet Manifold - Remove and Install
3500 and 3500B High Displacement Engines for Caterpillar Built Machines Fuel Priming Pump - Remove and Install
3500 and 3500B High Displacement Engines for Caterpillar Built Machines Electric Starting Motor - Remove and Install
SR4BHV and SR4HV Electric Power Generation Connection Diagram - SR4 HV ; SR4B HV Drawings of Customer Installed Options
C-10 and C-12 Truck Engines Housing (Front)
C9 Urban Transit Bus Engine Alternator and Regulator
SR4BHV and SR4HV Electric Power Generation Connection Diagram - SR4 HV ; SR4B HV Abbreviations
SR4BHV and SR4HV Electric Power Generation Connection Diagram - SR4 HV ; SR4B HV Basic Connection Diagrams
SR4BHV and SR4HV Electric Power Generation Connection Diagram - SR4 HV ; SR4B HV Connection Diagrams for Schematic Codes 10XXXX
SR4BHV and SR4HV Electric Power Generation Connection Diagram - SR4 HV ; SR4B HV Connection Diagrams for Schematic Codes 11XXXX
G3304 and G3306 Engines Turbocharger - Remove
SR4BHV and SR4HV Electric Power Generation Connection Diagram - SR4 HV ; SR4B HV Connection Diagrams for Schematic Codes 12XXXX
G3304 and G3306 Engines Turbocharger - Install
C11, C13 and C15 On-highway Engines 0001-05 Cylinder #1 Injector current low (72)
C11, C13 and C15 On-highway Engines 0001-06 Cylinder #1 Injector current high (72)
C11, C13 and C15 On-highway Engines 0002-05 Cylinder #2 Injector current low (72)
C11, C13 and C15 On-highway Engines 0002-06 Cylinder #2 Injector current high (72)
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.