C-18 Truck Engines Caterpillar


Customer Specified Parameters

Usage:

C-18 MDP
To record programmed specifications, use the following blanks.

"Passwords"

  • "Customer Password #1"____________________

  • "Customer Password #2"____________________

"Selected Engine Rating Parameters"

  • "Rating Number"____________________

  • "Multi-Torque Ratio"____________________

"ECM Identification Parameters" ____________________

  • "Vehicle ID"____________________

  • "Engine Serial Number"____________________

"Security Access Parameters"

  • "ECM Wireless Communications Enable"____________________

"Vehicle Speed Parameters"

  • "Vehicle Speed Calibration"____________________PPKM (PPM)

  • "Vehicle Speed Calibration (J1939 - Trans)"____________________

  • "Vehicle Speed Calibration (J1939 - ABS)"____________________

  • "Vehicle Speed Limit"____________________km/h (mph)

  • "Vehicle Speed Limit Protection"____________________rpm

  • "Tachometer Calibration"____________________ pulses per revolution

  • "Soft Vehicle Speed Limit"____________________

  • "Low Speed Range Axle Ratio"____________________

  • "High Speed Range Axle Ratio"____________________

"Cruise Control Parameters"

  • "Low Cruise Control Speed Set Limit"____________________km/h (mph)

  • "High Cruise Control Speed Set Limit"____________________km/h (mph)

  • "Engine Retarder Mode"____________________

  • "Engine Retarder Minimum VSL Type"____________________

  • "Engine Retarder Minimum Vehicle Speed"km/h (mph)____________________

  • "Auto Retarder in Cruise"____________________

  • "Auto Retarder in Cruise Increment"____________________

  • "Cruise/Idle/PTO Switch Configuration"____________________

  • "Soft Cruise Control"____________________

  • "Adaptive Cruise Control Enable"____________________

"Idle Parameters"

  • "Idle Vehicle Speed Limit"____________________km/h (mph)

  • "Idle RPM Limit"____________________rpm

  • "PTO Engine Speed Ramp Rate"____________________ rpm/sec

  • "PTO Bump RPM"____________________rpm

"Dedicated PTO Parameters"

  • "PTO Configuration"____________________

  • "PTO Top Engine Limit"____________________rpm

  • "PTO Engine RPM Set Speed"____________________rpm

  • "PTO Engine RPM Set Speed A"____________________rpm

  • "PTO Engine RPM Set Speed B"____________________rpm

  • "PTO to Set Speed"____________________

  • "Maximum PTO Enable Speed"____________________rpm

  • "PTO Cab Controls RPM Limit"____________________rpm

  • "PTO Kickout Vehicle Speed Limit"____________________km/h (mph)

  • "Torque Limit"____________________N·m (lb ft)

  • "PTO Shutdown Time"____________________minutes

  • "PTO Shutdown Timer Maximum RPM"____________________rpm

  • "PTO Activates Cooling Fan"____________________

"Engine/Gear Parameters"

  • "Lower Gears Engine RPM Limit"____________________rpm

  • "Lower Gears Turn Off Speed"____________________km/h (mph)

  • "Intermediate Gears Engine RPM Limit"____________________rpm

  • "Intermediate Gears Turn Off Speed"____________________km/h (mph)

  • "Gear Down Protection RPM Limit"____________________rpm

  • "Gear Down Protection Turn On Speed"____________________km/h (mph)

  • "Top Engine Limit (TEL)"____________________rpm

  • "Top Engine Limit with Droop"____________________

  • "Low Idle Engine RPM"____________________rpm

  • "Transmission Style (If Equipped)"____________________

  • "Eaton Top 2 Override with Cruise Switch"____________________

  • "Top Gear Ratio"____________________

  • "Top Gear Minus One Ratio"____________________

  • "Top Gear Minus Two Ratio"____________________

  • "Governor Type"____________________

"Timer Parameters"

  • "Idle Shutdown Time"____________________minutes

  • "Idle Shutdown Timer Maximum RPM"____________________rpm

  • "Idle Shutdown Override Allowance"____________________

  • "Minimum Shutdown Idle Shutdown Outside Temperature"____________________ °C (°F)

  • "Maximum Shutdown Idle Shutdown Outside Temperature"____________________ °C (°F)

  • "A/C Switch Fan On - Time (If Equipped)"____________________seconds

  • "Fan with Engine Retarder in Hihg Mode (If Equipped)"____________________

  • "Engine Retarder Delay"____________________seconds

"Smart Idle Parameters"

  • "Battery Monitor and Engine Control Voltage"____________________volts

"Engine Monitoring Parameters"

  • "Engine Monitoring Mode"____________________

  • "Engine Monitoring Lamps"____________________

  • "Coolant Level Sensor" (If Equipped) ____________________

"Maintenance Parameters"

  • "Maintenance Indicator Mode"____________________

  • "PM1 Interval"____________________kilometers (miles) or hours

  • "Engine Oil Capacity"____________________L (qt)

"Trip Parameters"

  • "Fuel Correction Factor"____________________

  • "Dash-Change Fuel Correction Factor"____________________

  • "Dash - PM1 Reset"____________________

  • "Dash - Fleet Trip Reset"____________________

  • "Dash - State Selection"____________________

  • "Theft Deterrent System Control"____________________

  • "Theft Deterrent Password"____________________

  • "Quick Stop Rate"____________________kilometers per hour per second (miles per hour per second)

"Vehicle Activity Report"

  • Minimum Idle Time ____________________minutes

"Driver Reward"

  • Driver Reward Enable ____________________

"Input Selections"

  • "Fan Override Switch"____________________

  • "Ignore Brake/Clutch Switch"____________________

  • "Torque Limit Switch"____________________

  • "Diagnostic Enable"____________________

  • "PTO On/Off Switch"____________________

  • "Remote PTO Set Switch"____________________

  • "Remote PTO Resume Switch"____________________

  • "PTO Engine RPM Set Speed Input A"____________________

  • "PTO Engine RPM Set Speed Input B"____________________

  • "Starting Aid On/Off Switch"____________________

  • "Two-Speed Axle Switch"____________________

  • "Cruise Control On/Off Switch"____________________

  • "Cruise Control Set/Resume Switch"____________________

  • "Cruise Control Pause Switch"____________________

  • "Clutch Pedal Position Switch"____________________

  • "Retarder Off/Low/Medium/High Switch"____________________

  • "Service Brake Pedal Position Switch 1"____________________

  • "Accelerator Pedal Position"____________________

  • "Vehicle Speed Input"____________________

"Output Selections"

  • "Engine Running Output"____________________

  • "Engine Shutdown Output"____________________

  • "Auxiliary Brake"____________________

  • "Starting Aid Output"____________________

  • "Air Inlet Shutoff Relay Control"____________________

  • "Fan Control Type"____________________

  • "PTO Active Output"____________________

"Data Link Parameters"

  • "Powertrain Data Link"____________________

"System Parameters"

  • "Personality Module Code"____________________

  • "FLS"____________________

  • "FTS"____________________

Caterpillar Information System:

C-15 Truck Engine Electric Starting Motor
C0.5, C0.7, C1.1/3011C, C1.5/3013C, C1.6 and C2.2/3024C/3024CT Industrial Engines and Engines for Caterpillar Built Machines Fuel System - Prime
C-18 Truck Engines Engine Operation
3512B Marine Auxiliary Engine Manual Barring Group - Air Interlock
C0.5, C0.7, C1.1/3011C, C1.5/3013C, C1.6 and C2.2/3024C/3024CT Industrial Engines and Engines for Caterpillar Built Machines Electrical System
Torque Specifications Ground Engaging Tool (G.E.T.) Fasteners
Torque Specifications Bulkhead Nuts
Torque Specifications Air Brake Fittings
C0.5, C0.7, C1.1/3011C, C1.5/3013C, C1.6 and C2.2/3024C/3024CT Industrial Engines and Engines for Caterpillar Built Machines Alternator and Regulator
2002/08/01 Relocation Of The Service Center For 3600 Fuel Injectors {1254}
G3500B Engines Electronic Control Module (ECM) - 20 Cylinders
2002/08/01 2002A Service Pack 1 for Caterpillar Electronic Technician (Cat ET) is now available {0785}
797 and 797B Off-Highway Truck Power Train Electronic Control System Electronic Control Module (ECM) - Flash Program
C0.5, C0.7, C1.1/3011C, C1.5/3013C, C1.6 and C2.2/3024C/3024CT Industrial Engines and Engines for Caterpillar Built Machines Fuel System
2002/08/01 Guidelines for Water Pump Visual Inspection {1361}
G3500B Engines Crankshaft Position for Valve Lash Setting
2002/08/01 The Routing Has Been Changed For The New Vent Line In The Oil Level Regulator Groups {1334}
C-10, C-12 and C-15 On-highway Engines 0110-11 Very High Coolant Temperature (61)
C-10, C-12 and C-15 On-highway Engines 0110-00 High Coolant Temperature Warning (61)
797 Off-Highway Truck Hydraulic System Screen (Hoist)
C0.5, C0.7, C1.1/3011C, C1.5/3013C, C1.6 and C2.2/3024C/3024CT Industrial Engines and Engines for Caterpillar Built Machines Connecting Rod - Inspect
C-15 On-Highway Engine Air Inlet and Exhaust System
C-15 On-Highway Engine Basic Engine
C-15 On-Highway Engine Electronic Control System Components
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.