Turbocharger - Install
Installation Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install a new gasket and turbocharger (2) into position on the exhaust manifold.
Show/hide table
Illustration 1 | g00809542 |
- Install three nuts (3) that fasten turbocharger (2) to the exhaust manifold. Tighten the nuts to a torque of 22 N·m (16 lb ft).
- Connect oil line (4) to turbocharger (2) .
- Connect oil drain hose onto turbocharger (2) and tighten hose clamp (5) .
Show/hide table
Illustration 2 | g00809711 |
- Install turbocharger cover (1) onto turbocharger (2) .
Show/hide table
Illustration 3 | g00809600 |
End By:
- Install the air inlet elbow. Refer to Disassembly and assembly, "Air Inlet Elbow - Remove and Install".
- Install the air cleaner assembly. Refer to Disassembly and assembly, "Air Cleaner - Remove and Install".
- Install the exhaust elbow. Refer to Disassembly and assembly, "Exhaust Elbow - Remove and Install".
Caterpillar Information System:
C15 Petroleum Generator Set Engines Electronic Unit Injector Mechanism
3406E Truck Engines Fuel System
3034 Marine Engine Turbocharger - Remove
735 Articulated Truck Power Train Transmission Mounting - TH35 Transmission to Engine
C32 Auxiliary Engine Sea Water Strainer - Clean/Inspect
3034 Marine Engine Fuel Conservation Practices
320B, 320B L and 320B N Excavators Travel in Water and Mud
G3500 Engines Engine Monitoring System
UPS 250, UPS 300, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supply Power Supply - Remove and Install - Single or Dual Input without Maintenance Bypass
C-9 Industrial Engine Engine Temperature Sensor Open or Short Circuit - Test
CPT372 Truck Mounted Pumper Engine Oil and Filter - Change
Wabco Air Compressors Air Compressor Leaks Coolant
3512B Marine Auxiliary Engine Engine Sensor Open/Short Test
3512B Marine Auxiliary Engine Engine Speed/Timing Sensor
37-MT, 41-MT, and 42-MT Series Starting Motors General Information
3034 Marine Engine Air Inlet Elbow - Remove and Install
C-15 and C-16 Industrial Engines Engine Oil and Filter - Change
3512B Marine Auxiliary Engine Secondary ECM/Personality Module
3034 Marine Engine Heat Exchanger - Remove
3456 Generator Sets Generator Operation
3512B Marine Auxiliary Engine Starting Motor System
3456 Generator Sets Bearing - Lubricate
3512B Marine Auxiliary Engine Analog Sensor - Calibrate
3034 Marine Engine Heat Exchanger - Install