Cab Air Filter - Clean/Replace
Show/hide table
| |
| Illustration 1 | g03421010 |
|
The filter element for the cab is located behind the operator station. | |
- Prepare the machine for maintenance. Refer to Operation and Maintenance Manual, "Prepare the Machine for Maintenance".
- Pull latch and remove cover (2) and replace the filter element (1).
- Install the clean filter element and the cover. Tighten the retaining screws.
Note: When rips or tears are noticed in the filter element, install a new filter element. When a reduction of air circulation is noticed in the cab after cleaning the filter element, install a new filter element.
Caterpillar Information System:
Installation of the 390-1561 Front Lines Gp on Certain Excavators{5057} Installation of the 390-1561 Front Lines Gp on Certain Excavators{5057}
794 AC Off-Highway Truck Automatic Lubrication Reservoir - Fill
349F and 352F Excavators Switch Circuits - Test
349F and 352F Excavators Window Wiper Delay - Test
Steering Column Difficult or Unable to Adjust on Certain M300D Wheeled Excavators{4310} Steering Column Difficult or Unable to Adjust on Certain M300D Wheeled Excavators{4310}
PM620 and PM622 Cold Planer Slope Operation
2013/08/19 New Software Is Now Available For All Cat® Products With PL522 China System {7606, 7620}
Procedure to Rework the Ground Harness for the Display Panel and Fuel Sender for 307E Mini Hydraulic Excavators{1408} Procedure to Rework the Ground Harness for the Display Panel and Fuel Sender for 307E Mini Hydraulic Excavators{1408}
M316C Excavator Machine System Pilot Lines
M316C Excavator Machine System Pilot Lines
M316C Excavator Machine System Hydraulic Fan Drive Lines
M316C Excavator Machine System Hydraulic Tank and Filter
794 AC Off-Highway Truck Engine Air Precleaner - Clean
794 AC Off-Highway Truck Frame and Body - Inspect
794 AC Off-Highway Truck Frame and Body Support Pads - Clean/Inspect
M316C Excavator Machine System Pilot Lines
M316C Excavator Machine System Pilot Lines
M316C Excavator Machine System Pilot Lines
M316C Excavator Machine System Swing Motor Lines
M316C Excavator Machine System Fuel Lines
349F and 352F Excavator Machine System Wiring Harness (Open Circuit) - Test
349F and 352F Excavator Machine System Wiring Harness (Short Circuit) - Test
349F and 352F Excavators Solenoid Valve (Switch Controlled) - Test
349F and 352F Excavators Engine Supplement Temperature Sensor (Catalyst Inlet) - Remove and Install