Engine Air Precleaner - Clean
Show/hide table
Illustration 1 | g03421035 |
Note: In order to access the engine air precleaners, it may be necessary to use a portable access system (ladder, stair assembly, man lift, or other portable access system) that is suitable and compliant to local regulations.
Show/hide table
Illustration 2 | g01180274 |
Note: Do not paint dust valves (3). Paint will cause the rubber to harden and the rubber may not seal properly.
Perform the following procedure for each engine air precleaner (4).
- Prepare the machine for maintenance. Refer to Operation and Maintenance Manual, "Prepare the Machine for Maintenance".
- Loosen clamp (1) on the precleaner and remove lower precleaner bowl (2) and dust valve (3).
- Clean the lower precleaner bowl and the dust valve with air pressure.
- Make sure that all of the tubes within the precleaner are free of dirt. Clean the tubes, if necessary.
- Install the clean lower pre-cleaner bowl, and the clean dust valve and tighten the clamp on the precleaner.
- Repeat steps 2 through 5 for each precleaner.
Show/hide table
NOTICE |
---|
Do not operate the machine with the dust valves removed. Engine damage can occur. |
Caterpillar Information System:
794 AC Off-Highway Truck Cab Air Filter - Clean/Replace
Installation of the 390-1561 Front Lines Gp on Certain Excavators{5057} Installation of the 390-1561 Front Lines Gp on Certain Excavators{5057}
794 AC Off-Highway Truck Automatic Lubrication Reservoir - Fill
349F and 352F Excavators Switch Circuits - Test
349F and 352F Excavators Window Wiper Delay - Test
Steering Column Difficult or Unable to Adjust on Certain M300D Wheeled Excavators{4310} Steering Column Difficult or Unable to Adjust on Certain M300D Wheeled Excavators{4310}
PM620 and PM622 Cold Planer Slope Operation
2013/08/19 New Software Is Now Available For All Cat® Products With PL522 China System {7606, 7620}
Procedure to Rework the Ground Harness for the Display Panel and Fuel Sender for 307E Mini Hydraulic Excavators{1408} Procedure to Rework the Ground Harness for the Display Panel and Fuel Sender for 307E Mini Hydraulic Excavators{1408}
M316C Excavator Machine System Pilot Lines
M316C Excavator Machine System Pilot Lines
M316C Excavator Machine System Hydraulic Fan Drive Lines
794 AC Off-Highway Truck Frame and Body - Inspect
794 AC Off-Highway Truck Frame and Body Support Pads - Clean/Inspect
M316C Excavator Machine System Pilot Lines
M316C Excavator Machine System Pilot Lines
M316C Excavator Machine System Pilot Lines
M316C Excavator Machine System Swing Motor Lines
M316C Excavator Machine System Fuel Lines
349F and 352F Excavator Machine System Wiring Harness (Open Circuit) - Test
349F and 352F Excavator Machine System Wiring Harness (Short Circuit) - Test
349F and 352F Excavators Solenoid Valve (Switch Controlled) - Test
349F and 352F Excavators Engine Supplement Temperature Sensor (Catalyst Inlet) - Remove and Install
349F and 352F Excavators Solenoid Valve - Test