Water Pump
Usage:
(1) Torque for three long studs in cylinder block ... 35 ± 5 N·m (26 ± 4 lb ft)
NOTE: Put 9S3263 Thread Lock on threads of short stud in front housing.
(2) Oil seal. Put clean engine oil on the seal lip. Assemble with the lip toward the bearings.
(3) Seal. Put a thin layer of clean engine oil in the bore for the seal.
(4) Ring and water seal.
(5) Seal assembly.
NOTE: For proper installation procedure of the seals, refer to the Disassembly & Assembly module.
(6) Shaft diameter at carbon seal assembly seat area must be ... 19.10 ± 0.05 mm (.752 ± .002 in)
(7) Torque for the bolt that holds the impeller ... 39 ± 3 N·m (29 ± 2 lb ft)
Caterpillar Information System:
3408C & 3412C INDUSTRIAL ENGINES Oil Breather Cap
3408C & 3412C INDUSTRIAL ENGINES Oil Pan
3408C & 3412C INDUSTRIAL ENGINES Engine Oil Pressure
3408C & 3412C INDUSTRIAL ENGINES Engine Oil Bypass Valve
3408C & 3412C INDUSTRIAL ENGINES Engine Oil Filters And Lines Group
3408C & 3412C INDUSTRIAL ENGINES Engine Oil Pump
3408C & 3412C INDUSTRIAL ENGINES Turbocharger Lines Group
3408C & 3412C INDUSTRIAL ENGINES Turbocharger
3408C & 3412C INDUSTRIAL ENGINES Trunnion Group
3408C & 3412C INDUSTRIAL ENGINES Aftercooler Group
3408C & 3412C INDUSTRIAL ENGINES Exhaust Manifolds
3408C & 3412C INDUSTRIAL ENGINES Inlet Air And Exhaust Lines
3408C & 3412C INDUSTRIAL ENGINES Coolant Conditioner Base
3408C & 3412C INDUSTRIAL ENGINES Water Temperature Regulator
3408C & 3412C INDUSTRIAL ENGINES Belt Tension Chart
3408C & 3412C INDUSTRIAL ENGINES Cylinder Block
3408C & 3412C INDUSTRIAL ENGINES Cylinder Liners
3408C & 3412C INDUSTRIAL ENGINES Cylinder Liner Projection
3408C & 3412C INDUSTRIAL ENGINES Crankshaft
3408C & 3412C INDUSTRIAL ENGINES Crankshaft Rear Gear
3408C & 3412C INDUSTRIAL ENGINES Connecting Rod And Main Bearing Journals
3408C & 3412C INDUSTRIAL ENGINES Connecting Rod
3408C & 3412C INDUSTRIAL ENGINES Pistons And Rings
3408C & 3412C INDUSTRIAL ENGINES Flywheel Housing Cover Group