Governor Control
Show/hide table
 | |
| Illustration 1 | g00735762 |
(1) Handle
-
4W-2542 Spring (inside of handle (1) )
- Length under test force ... 53.3 mm (2.10 inch)
- Test force ... 53.4 ± 4.3 N (12 ± 1 lb)
- Free length after test ... 98.0 mm (3.86 inch)
- Outside diameter ... 15.24 mm (0.600 inch)
- Test force ... 53.4 ± 4.3 N (12 ± 1 lb)
Be sure that handle (1) is in the vertical position and that lever (2) is in the horizontal position.
Governor lever (4) must be in the horizontal position.
Rotate rod (3) from the horizontal position in order to obtain fuel shutoff. Governor lever (4) is rotated downward from the horizontal position. If necessary, adjust the ends of the rod in order to obtain specified degree for the fuel shutoff.
Caterpillar Information System:
G3406 Engines Governor Fastener
2000/09/11 Explanation of Fuel Shutoff Solenoid Operation {1259}
2000/09/01 New Protective Sleeve Available For Hydrax Actuator Shaft {1716}
G3408C and G3412C Engines Cylinder Block, Liners and Heads
2000/09/01 Correction to Operation and Maintenance Manual, SEBU7074, "3306B and 3406C Generator Set Engines" {7002}
G3406 Engines Governor
2000/09/01 New Injector Wiring Harnesses Are Color Coded {1251, 1408}
3054, 3054B and 3056 Marine Engines Refill Capacities
C-10 and C-12 Industrial Engines Water Pump
SPS342 Skid Mounted Pumper Batteries - Replace
G3406 Engines Governor Drive
3508B Industrial Engines Testing the Radiator and Cooling System for Leaks
C-10 and C-12 Industrial Engines Electronic Control System Components
2000/09/01 New Coupling For Hydrax Actuator Position Sensor {1716}
G3408C and G3412C Engines Ignition System
G3406 Engines Auxiliary Drive
G3408C and G3412C Engines Electronic Control System Parameters
G3406 Engines Turbocharger
C-15 and C-16 Industrial Engines Air Starting System
C-10 and C-12 Industrial Engines Rear Power Take-Off (RPTO)
C-9 Engine for TK711, TK721, TK722, TK732, TK741, TK751, and TK752 Track Feller Bunchers CID 0042 FMI 11 Inject Actuation Control Valve open/short
3500 Engines For Caterpillar Built Power Modules Starting Solenoid
C-9 Engine for TK711, TK721, TK722, TK732, TK741, TK751, and TK752 Track Feller Bunchers CID 0094 FMI 03 Fuel Pressure open/short to +batt
C-9 Engine for TK711, TK721, TK722, TK732, TK741, TK751, and TK752 Track Feller Bunchers CID 0094 FMI 04 Fuel Pressure short to ground