Cylinder Block - Inspect
If the main bearing caps are installed without bearings, the bore in the block for the main bearings can be checked. Tighten the nuts that hold the caps to the torque that is shown in the Specifications, "Cylinder Block". Alignment error in the bores must not be more than 0.08 mm (.003 inch).
Refer to the Special Instruction, SMHS7606 for the use of the 1P-4000 Line Boring Tool Group for the alignment of the main bearing bores. The 1P-3537 Dial Bore Gauge Group can be used to check the size of the bores. The Special Instruction, GMGO0981 is with the group.
Show/hide table
 | |
| Illustration 1 | g00285686 |
1P-3537 Dial Bore Gauge Group | |
Caterpillar Information System:
3306C Truck Engine Flywheel - Inspect
3306C Truck Engine Flywheel Housing - Inspect
3306C Truck Engine Vibration Damper - Check
3500B Engines for Caterpillar Built Power Modules General Information
JF Series Starting Motor Starting Motor - Disassemble
Alternator - Delco 27SI Brush Length - Check
JF Series Starting Motor Starting Motor Does Not Turn or Turns Slowly
G3516B Engines Oxygen Sensor Signal
3306C Truck Engine Engine Oil Pressure - Test
Electronic Modular Control Panel II+ (EMCP II+) GSC CID 0445 - FMI 12 (for PEEC Engines)
3306C Truck Engine Engine Valve Lash - Inspect/Adjust
3306C Truck Engine Compression - Test
3306C Truck Engine Cylinder Liner Projection - Inspect
3306C Truck Engine Main Bearings - Inspect
Alternator - Delco 21SI Field Winding - Test
EMCP3 General Information
Electronic Modular Control Panel II (EMCP II) Service Tools
Electronic Modular Control Panel II+ (EMCP II+) Fault Identification
Electronic Modular Control Panel II+ (EMCP II+) Troubleshooting Diagnostic Codes
3306C Truck Engine Battery - Test
3306C Truck Engine Charging System - Test
Electronic Modular Control Panel II+ (EMCP II+) GSC CID 0446 - FMI 12
2000/07/01 The Use Of The 179-1502 Oil Filter Element Will Extend Oil Change Intervals For G3600 Engines {1308}
3306C Truck Engine Electric Starting System - Test