Radiator Core - Clean
Show/hide table
高压空气会造成人身伤害。 不按下面的适当步骤进行操作会造成人身伤害。 使用压缩空气时,戴防护面罩及穿防护服。 用做清洗用途时,喷嘴处最大空气压力必须低于205 kPa (30 psi) 。 |
- 抬起发动机罩,打开位于机器左侧的检修门。
- 卸掉销 (1) 。
Show/hide table
图 1 | g01366489 |
- 拆下滤网 (2) 和 (3) 。
- 检查所有的散热器芯散热片上有无碎屑。
Show/hide table
图 2 | g01366490 |
(4) 液压油冷却器 (5) 空冷后冷器( ATAAC (6) 散热器芯 |
- 清除散热器所有芯翅片上和滤网上的尘土和碎屑。
优先使用压缩空气,但也可以使用高压水或蒸汽来除去散热器芯上的尘土和一般碎屑。
有关清洁散热器芯片的详细资料,请参阅专门出版物, SEBD0518, "了解您的冷却系统"。
- 安装滤网 (2) 和 (3) 。
- 安装销 (1) 。
- 关闭发动机罩,关闭检修门。
侧部滤网
Show/hide table
图 3 | g01268061 |
- 卸下 3 个螺栓 (1) 和 3 个垫圈 (2) 。
- 打开滤网盖 (3) 。
- 拆下滤网 (4) 和 (5) 。
- 清除滤网的尘土和碎屑。
优先使用压缩空气,但也可以使用高压水或蒸汽来除去滤网上的尘埃和碎屑。
- 安装滤网 (4) 和 (5) 。
- 关闭滤网盖 (3) 。
- 安装 3 个螺栓 (1) 和 3 个垫圈 (2) 。
顶部滤网
Show/hide table
图 4 | g01268079 |
- 卸下 3 个螺栓 (6) 。
- 卸下 3 个滤网 (7) 。
- 清除滤网的尘土和碎屑。
优先使用压缩空气,但也可以使用高压水或蒸汽来除去滤网上的尘埃和碎屑。
- 安装 3 个滤网 (7) 。
- 安装 3 个螺栓 (6) 。
Caterpillar Information System:
330D Excavator Forest Machine C9 Engine Supplement Engine Rear Mount - Remove
330D Excavator Forest Machine C9 Engine Supplement Engine Front Mount - Install
330D Excavator Forest Machine C9 Engine Supplement Engine Front Mount - Remove
Procedure to Convert Coupler for Use On 950H and 962H Wheel Loaders{6129} Procedure to Convert Coupler for Use On 950H and 962H Wheel Loaders{6129}
330D Excavator Forest Machine C9 Engine Supplement Aftercooler - Install
M313D, M315D, M316D, M318D and M322D Excavators and M316D MHPU Mobile Hydraulic Power Unit Electronic System MID 039 - CID 1558 - FMI 14
330D Excavator Forest Machine C9 Engine Supplement Aftercooler - Remove
2007/04/16 An Improved Hose Routing Helps Prevent Damage to Hoses {5057}
2007/04/23 Repair Procedure for Damaged Spillguards on Wheel Loader Buckets {6101, 6102, 7000}
330D Excavator Forest Machine C9 Engine Supplement Refrigerant Condenser and Fan Motor - Remove and Install
3176C, 3406E and 3456 Industrial Engines Exhaust System Contains Oil
325D and 329D Excavators and 329D MHPU Mobile Hydraulic Power Unit Specifications - 325D and 329D Ditch Cleaner
330D and 336D Excavators Hydraulic System Relief Valve (Line) - Test and Adjust
330D Excavator Forest Machine C9 Engine Supplement Engine Rear Mount - Install
568 Forest Machines Machine Systems Load Control Valve (Stick Cylinder) - Remove
A Procedure to Remove the Check Valve on Certain Field Installed Quick Coupler Lines Groups{5057, 6129, 7000} A Procedure to Remove the Check Valve on Certain Field Installed Quick Coupler Lines Groups{5057, 6129, 7000}
365C MHPU Mobile Hydraulic Power Unit Hydraulic System Main Pump (Flow) - Test - Constant Horsepower Flow Control
325C MHPU Mobile Hydraulic Power Unit Hydraulic System Oil - Change
325C MHPU Mobile Hydraulic Power Unit Hydraulic System Main Pump (Flow) - Test - Constant Horsepower Flow Control
365C MHPU Mobile Hydraulic Power Unit Hydraulic System Accumulator (Pilot) - Test and Charge
568 Forest Machines Machine Systems Load Control Valve (Stick Cylinder) - Install
330D Forest Machine Machine Systems Load Control Valve (Boom Cylinder) - Remove
325C MHPU Mobile Hydraulic Power Unit Hydraulic System Oil Filter (Case Drain) - Replace
M315D2 and M317D2 Excavators Automatic Lubrication Grease Tank - Fill - If Equipped