Valve Cover Base
Usage:
Remove and Install Valve Cover Base
Start By:
a. remove valve covers
1. Loosen the two nuts and remove connector (2) from electronic unit injector (1).
2. Remove connector (3) from valve cover base (4).
3. Remove bolts (5) from the valve cover base. For purposes of assembly, the torque for bolts (5) is 18 ± 3 N·m (13 ± 2 lb ft). Remove the valve cover base.
4. Remove seal (6) from valve cover base (4). If the part is worn or damaged, replace the part.
Show/hide table
NOTICE |
---|
For further information concerning the installation and tightening sequence for the valve cover base, refer to the Specifications, "Valve Covers and Base" for additional information. |
5. Install valve cover base (4) in the reverse order of removal.
End By:
a. install the valve covers
Caterpillar Information System:
3406E TRUCK ENGINE Valve Covers
3406E TRUCK ENGINE Pump Drive
3406E TRUCK ENGINE Timing Gears and Plate
3406E TRUCK ENGINE Timing Gear Cover
3406E TRUCK ENGINE Vibration Damper and Pulley
3406E TRUCK ENGINE Engine Front Support
3406E TRUCK ENGINE Fan Drive
3406E TRUCK ENGINE Water Pump
3406E TRUCK ENGINE Exhaust Manifold
3406E TRUCK ENGINE Oil Filter and Base
3406E TRUCK ENGINE Engine Oil Cooler
3406E TRUCK ENGINE Water Temperature Regulators
3406E TRUCK ENGINE Rocker Arm and Shaft Assemblies
3406E TRUCK ENGINE Cylinder Head Assembly
3406E TRUCK ENGINE Spacer Plate
3406E TRUCK ENGINE Valve Springs
3406E TRUCK ENGINE Inlet and Exhaust Valves
3406E TRUCK ENGINE Valve Seals
3406E TRUCK ENGINE Valve Seat Inserts
3406E TRUCK ENGINE Valve Guides
3406E TRUCK ENGINE Oil Pan
3406E TRUCK ENGINE Flywheel
3406E TRUCK ENGINE Flywheel Housing
3406E TRUCK ENGINE Oil Pump