Valve Covers
Usage:
Remove and Install Valve Covers
1. Remove bolts (1) that hold valve cover to (2) valve cover base. Remove valve cover (2).
2. Check the condition of the valve cover seal (3). If the part is worn or damaged, replace the part.
NOTE: The following steps are for installation of the valve covers.
Show/hide table
NOTICE |
---|
For further information concerning the installation and tightening sequence for the valve cover base, refer to the Specifications, "Valve Covers and Base" for additional information. |
3. Put valve cover (2) in position on the valve cover base. Install the bolts that hold the valve cover in place. Tighten the bolts to a torque of 18 ± 3 N·m (13 ± 2 lb ft).
Caterpillar Information System:
3406E TRUCK ENGINE Pump Drive
3406E TRUCK ENGINE Timing Gears and Plate
3406E TRUCK ENGINE Timing Gear Cover
3406E TRUCK ENGINE Vibration Damper and Pulley
3406E TRUCK ENGINE Engine Front Support
3406E TRUCK ENGINE Fan Drive
3406E TRUCK ENGINE Water Pump
3406E TRUCK ENGINE Exhaust Manifold
3406E TRUCK ENGINE Oil Filter and Base
3406E TRUCK ENGINE Engine Oil Cooler
3406E TRUCK ENGINE Water Temperature Regulators
3406E TRUCK ENGINE Turbocharger
3406E TRUCK ENGINE Valve Cover Base
3406E TRUCK ENGINE Rocker Arm and Shaft Assemblies
3406E TRUCK ENGINE Cylinder Head Assembly
3406E TRUCK ENGINE Spacer Plate
3406E TRUCK ENGINE Valve Springs
3406E TRUCK ENGINE Inlet and Exhaust Valves
3406E TRUCK ENGINE Valve Seals
3406E TRUCK ENGINE Valve Seat Inserts
3406E TRUCK ENGINE Valve Guides
3406E TRUCK ENGINE Oil Pan
3406E TRUCK ENGINE Flywheel
3406E TRUCK ENGINE Flywheel Housing