Upper Frame
Show/hide table
Illustration 1 | g00487383 |
Note: Coat all pin bores with lubricant.
(1) Use shims to adjust the lateral clearance.
- Assembled lateral clearance ... 1.6 mm (0.06 inch)
- 4I-0577 Shim ... 2.0 mm (0.08 inch)
- Two 4I-0575 Shims ... 1.0 mm (0.04 inch)
- 133-2428 Shim ... 0.5 mm (0.02 inch)
- 4I-0577 Shim ... 2.0 mm (0.08 inch)
(2) 186-5656 Pin Assembly
- Maximum diameter after plating ... 109.850 ± 0.040 mm (4.3248 ± 0.0016 inch)
- Minimum thickness for plating ... 0.005 mm (0.0002 inch)
(3) 186-5663 Pin Assembly
- Maximum diameter after plating ... 99.850 ± 0.040 mm (3.9311 ± 0.0016 inch)
- Minimum thickness for plating ... 0.005 mm (0.0002 inch)
(4) Use shims to adjust the lateral clearance.
- Four 166-1488 Shims ... 2.00 ± 0.15 mm (0.079 ± 0.006 inch)
Caterpillar Information System:
SR17, SR18, SR21, SR318 and SR321 Snowblowers Operation
305 CR Mini Hydraulic Excavator Cooling System Pressure Cap - Clean/Replace
G3500B Engines Compression
322C Excavator Machine System Specifications Fuel Tank
BH27, BH30 and BH30 W Skid Steer Loader Backhoes Boom Cylinder - Remove and Install
5130B Excavator Bearing (Swing Drive) - Lubricate
3126B Engines for the IT38G Series II Integrated Toolcarrier and the 938G Series II Wheel Loader Diagnostic Codes
3456 Engine for Caterpillar Built Machines CAT Data Link Circuit - Test
312C Excavator Machine Systems Swing Drive - Disassemble - Older Style
3456 Engine for Caterpillar Built Machines Diagnostic Codes
CVP16, CVP40, CVP75 and CVP110 Vibratory Plate Compactors Operation
305 CR Mini Hydraulic Excavator Work Tool Control - If Equipped
CVP16, CVP40, CVP75 and CVP110 Vibratory Plate Compactors Reference Material
CVP16, CVP40, CVP75 and CVP110 Vibratory Plate Compactors Transport Position
SR17, SR18, SR21, SR318 and SR321 Snowblowers Chain - Lubricate
SR17, SR18, SR21, SR318 and SR321 Snowblowers Discharge Chute Chain - Adjust/Replace
CVP16, CVP40, CVP75 and CVP110 Vibratory Plate Compactors Lifting and Tying Down
SR17, SR18, SR21, SR318 and SR321 Snowblowers Cutting Edge - Replace
320C U Excavator Lifting Capacities
3176C, 3196 and 3406E Engines for Caterpillar Built Machines Digital Sensor Supply Circuit - Test
325C Excavator Machine System Specifications Auxiliary Hydraulic Lines - Stick 2500 mm (98 inch)
325C Excavator Machine System Specifications Auxiliary Hydraulic Lines - Stick 2600 mm (102 inch)
325C Excavator Machine System Specifications Auxiliary Hydraulic Lines - Stick 3200 mm (126 inch)
SR17, SR18, SR21, SR318 and SR321 Snowblowers Reference Material