3064 and 3066 Engines for Caterpillar Built Machines Caterpillar


Engine Oil Pressure - Test

Usage:

320B L 1ES

表 1
所需工具    
零件号     零件名称     数量    
1U-5470     发动机压力表总成     1    

有故障的机油压力计可能会指示机油压力过低。

1U-5470 发动机压力表总成 可用于检查发动机机油压力。




图 1g00296486

1U-5470 发动机压力总成

1U-5470 发动机压力表总成 具有可用来测量发动机中机油压力的仪表。 有关使用 1U-5470 发动机压力表总成 的更多信息,请参阅专门说明书, SEHS8907。 该信息包括在机具总成中。

  1. 确保发动机被加注到正确的机油油位。

  1. 1U-5470 发动机压力表总成 连接到机油测压口上。

  1. 运转发动机。 使发动机达到正常的工作温度。

  1. 发动机运转到额定转速以保持机油温度恒定。 读取压力表读数。

  1. 请参阅表 2,以确定发动机机油压力是否在公差范围内。

表 2
机油压力 (1)    
1500 rpm 时的机油压力    
196 到 392 kPa (28 到 57 psi)    
怠速时的机油压力 (2)    
83 到 98 kPa (12 到 14 psi)    
( 1 ) 机油温度必须为 60° 到 70°C (140° 到 158°F)。
( 2 ) 怠速 rpm 为 900 ± 20 rpm。

如果测试结果不在表 2 中的压力范围内,找出问题的原因并解决该问题。 持续在机油压力超出此范围的情况下运转发动机会造成发动机故障或发动机使用寿命的减少。

注: 常规保养时对发动机机油压力的记录可用作发动机可能出现问题的指示。 常规保养时机油压力的记录也可用作发动机可能损坏的恒量指标。 在机油压力的突然升高或降低超过 70 kPa (10 psi) 时,应当检查发动机并修复故障。

Caterpillar Information System:

3500B Engines Throttle Switch
3500B Engines for 5130B and 5230B Excavators MID 036 - CID 0580 - FMI 08 Power Shift Pres Sensor signal is abnormal
3500B Engines for 5130B and 5230B Excavators MID 036 - CID 0580 - FMI 04 Power Shift Pres Sensor short to ground
305.5 Mini Hydraulic Excavator Machine System Specifications Control Manifold (Pilot Oil)
3500B Engines for 5130B and 5230B Excavators MID 036 - CID 0580 - FMI 03 Power Shift Pres Sensor open/short to +batt
3064 and 3066 Engines for Caterpillar Built Machines Valve Guide - Inspect
3064 and 3066 Engines for Caterpillar Built Machines Engine Valve Lash - Inspect/Adjust
3064 and 3066 Engines for Caterpillar Built Machines Engine Crankcase Pressure (Blowby) - Test
3064 and 3066 Engines for Caterpillar Built Machines Exhaust Temperature - Test
HDB Series and M1 Series Heavy Duty Brushless Alternators Normal Operation
303.5C CR and 303C CR Mini Hydraulic Excavators Machine System Specifications Joystick Control
3500B Engines for 5130B and 5230B Excavators MID 036 - CID 0547 - FMI 06 Ether Injection Lamp short to ground
3500B Engines for 5130B and 5230B Excavators MID 036 - CID 0581 - FMI 05 Power Shift Solenoid open circuit
3500B Engines for 5130B and 5230B Excavators MID 036 - CID 0581 - FMI 06 Power Shift Solenoid short to ground
3500B Engines for 5130B and 5230B Excavators MID 036 - CID 0581 - FMI 13 Power Shift Solenoid cal required
914G Compact Wheel Loader and IT14G Integrated Toolcarrier Transmission Electronic Control System Using Caterpillar Electronic Technician to Determine Diagnostic Codes
3064 and 3066 Engines for Caterpillar Built Machines Cooling System - Test
3500B Engines for 5130B and 5230B Excavators System Overview
5230B Excavator Electronic Systems Guide Vital Information Management System (VIMS)
3064 and 3066 Engines for Caterpillar Built Machines Electric Starting System - Test
325D and 329D Excavators Condenser (Refrigerant) - Clean
3500B Engines Electronic Control Terms
2001/07/30 Correctly Assembling the Buffer Seal Will Prevent Failure of the U-Cup Seals {7562}
312C Excavator 3064 Engine Supplement Water Pump - Remove
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.