Magnetic Pickup
Show/hide table
Illustration 1 | g00123133 |
Typical Example |
- Install the engine speed sensor into the 5/8 threaded hole and turn until the magnetic core makes contact with a tooth of the flywheel ring gear.
- Back out 180 degrees and tighten the locknut.
Torque ... 45 ± 7 N·m (33 ± 5 lb ft)
The clearance between the engine speed sensor and the flywheel ring gear is the following value: ... 0.55 to 0.83 mm (0.0217 to 0.0327 inch)
Caterpillar Information System:
G3612 and G3616 Engines Gas Admission Valve - Remove
3512B Marine Auxiliary Engine Fuel Filter
G3612 and G3616 Engines Rocker Arm - Install
G3612 and G3616 Engines Rocker Arm - Remove
3500 and 3500B High Displacement Engines for Caterpillar Built Machines Camshaft - Remove
3054B Industrial Engine Engine Description
3054B Industrial Engine Model View Illustrations
SR4B Generators Troubleshooting
3126B Engines for Caterpillar Built Machines Crankshaft Wear Sleeve (Rear) - Install
3114, 3116 and 3126 Engines Governor Instability
3114, 3116, and 3126 Engines for Caterpillar Built Machines Flywheel - Install
3512B Marine Auxiliary Engine Electronic Display Module
G3304 and G3306 Engines Cylinder Block
C-9 Engines for Caterpillar Built Machines Valve Mechanism
G3612 and G3616 Engines Gas Admission Valve - Install
SR4B Generators Generator Set - Test
G3612 and G3616 Engines Gas Admission Valve - Disassemble
C-9 Engines for Caterpillar Built Machines Cylinder Head Valves
3500 and 3500B High Displacement Engines for Caterpillar Built Machines Camshaft - Install
G3612 and G3616 Engines Gas Admission Valve - Assemble
3126B Engines for Caterpillar Built Machines Water Temperature Regulator - Remove and Install
3054B Industrial Engine Refill Capacities
G3612 and G3616 Engines Prechamber Check Valve - Remove and Install
G3406 Engines Air Starting Motor Pressure Regulating Valve