Valve Cover - Remove and Install
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove four bolts (1). Remove valve cover (2).
Show/hide table
Illustration 2 g00605124 - If necessary, remove O-ring seal (3).
Show/hide table
Illustration 1 | g00605123 |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Inspect O-ring seal (3) for good condition. Obtain a new seal, if necessary. Make sure that the seal is installed in the groove of valve cover (2). Place the valve cover onto rocker arm base (4).
Show/hide table
Illustration 4 g00605123 - Install four bolts (1). Tighten the bolts to a torque of
10 N·m (7 lb ft) . Tighten the bolts again to a torque of20 ± 3 N·m (15 ± 2 lb ft) .
Show/hide table
Illustration 3 | g00605124 |
Caterpillar Information System:
G3612 and G3616 Engines Crankcase Explosion Relief Valve - Remove and Install
G3612 and G3616 Engines Crankcase Pressure Sensor - Remove and Install
G3612 and G3616 Engines Exhaust Bypass - Install
3176B Marine Engine Starting the Engine
3114, 3116 and 3126 Engines Excessive Black Smoke
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Inlet Manifold - Install - 3013, 3014, and 3024 Engines
3114, 3116 and 3126 Engines Engine Will Not Crank
3606 and 3608 Engines General Information (Cooling System)
3114, 3116 and 3126 Engines Engine Vibration
3500B Engines Engine Oil Filter Base - Install - Spin-on Filters
3606 and 3608 Engines Pressure Regulating Valve
3500B Engines Engine Oil Filter Base - Assemble - Spin-on Filters
G3612 and G3616 Engines Coolant Mixer Housing - Remove and Install
3512B Marine Auxiliary Engines Rocker Shaft and Push Rods - Remove
3606 and 3608 Engines Connecting Rod Bearings
G3612 and G3616 Engines Water Pump - Remove
3512B Marine Auxiliary Engines Rocker Shaft and Push Rods - Install
G3612 and G3616 Engines Water Pump - Install
3114, 3116 and 3126 Industrial, Marine and Generator Set Engines Electric Starting Motor
3612 and 3616 Engines Water Pump - Disassemble
3408E and 3412E Engines for Caterpillar Built Machines Cylinder Liner - Install
3612 and 3616 Engines Water Pump - Assemble
3612 and 3616 Engines Water Pump Seal - Remove
3500B Engines Rocker Shaft - Disassemble