Inlet Manifold - Install - 3013, 3014, and 3024 Engines
Installation Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Note: The inlet manifold that is used on the 3013, 3014 and 3024 Engines is removable as a separate part. The inlet manifold on the 3003 engine is part of the valve mechanism cover.
- Clean the cylinder head surface and the spacer plate for the inlet manifold. Ensure that no debris or gasket material is remaining on the mating surfaces.
- Install new spacer plate gasket (4) for the inlet manifold on the cylinder head.
Show/hide table
Illustration 1 | g00592865 |
- Install spacer plate (3) for the inlet manifold.
Show/hide table
Illustration 2 | g00592858 |
- Install a new gasket for the inlet manifold and position inlet manifold (2) on the cylinder head.
Show/hide table
Illustration 3 | g00592847 |
- Install bolts (1) that fasten the inlet manifold to the cylinder head and tighten bolts (1) to the following torque:
3013 Engine ... 10 N·m (90 lb in)
3014 and 3024 Engines ... 14 N·m (10 lb ft)
Caterpillar Information System:
3114, 3116 and 3126 Engines Engine Will Not Crank
3606 and 3608 Engines General Information (Cooling System)
3114, 3116 and 3126 Engines Engine Vibration
3500B Engines Engine Oil Filter Base - Install - Spin-on Filters
3606 and 3608 Engines Pressure Regulating Valve
3500B Engines Engine Oil Filter Base - Assemble - Spin-on Filters
3306B Generator Set Electronic Modular Control Panel II (EMCP II)
3500B Engines Engine Oil Filter Base - Disassemble - Spin-on Filters
3500B Engines Engine Oil Filter Base - Remove - Spin-on Filters
3500B Engines Engine Oil Filter Housing - Install
3114, 3116 and 3126 Engines Engine Stalls at Low RPM
3114, 3116 and 3126 Engines Engine Oil in Exhaust System
3114, 3116 and 3126 Engines Excessive Black Smoke
3176B Marine Engine Starting the Engine
G3612 and G3616 Engines Exhaust Bypass - Install
G3612 and G3616 Engines Crankcase Pressure Sensor - Remove and Install
G3612 and G3616 Engines Crankcase Explosion Relief Valve - Remove and Install
3512B Marine Auxiliary Engines Valve Cover - Remove and Install
G3612 and G3616 Engines Coolant Mixer Housing - Remove and Install
3512B Marine Auxiliary Engines Rocker Shaft and Push Rods - Remove
3606 and 3608 Engines Connecting Rod Bearings
G3612 and G3616 Engines Water Pump - Remove
3512B Marine Auxiliary Engines Rocker Shaft and Push Rods - Install
G3612 and G3616 Engines Water Pump - Install