Air Starting Motor - Remove
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
注: 有几种不同的气动马达可供使用。 根据不同的气管组件起动马达的配置也不同。 下面是拆卸两个不同气动马达的示例。
- 切断压缩空气的供应。 净化气管和起动马达中排出的空气。
Show/hide table
图 1 g00597642 - 断开软管 (1)。
- 拆卸螺栓 (2)。
- 拆卸U形螺栓 (3)和管组件 (4)。
Show/hide table
图 2 g00597643 - 断开软管 (5)。
- 将适当起吊设备连在气动马达 (6)上。 气动马达 (6)的重量约为
48 kg (106 lb) . - 拆卸螺栓 (7)。 拆卸气动马达 (6)。 从气动马达 (6)盖和飞轮壳体之间的接头上拆卸密封垫。
- 切断压缩空气的供应。 净化气管和起动马达中排出的空气。
Show/hide table
图 3 g00615939 - 断开线束 (1)。
- 从弯头上断开管 (2)。
Show/hide table
图 4 g00615940 - 将适当起吊设备连在气动马达 (4)上。 气动马达 (4)的重量约为
86 kg (190 lb) 。 - 拆卸螺栓 (3)。 拆卸气动马达 (4)。 从气动马达 (4)盖和飞轮壳体之间的接头上拆卸密封垫。
Caterpillar Information System:
3114, 3116 and 3126 Industrial, Marine and Generator Set Engines Front Housing and Covers
G3606 and G3608 Engines Hydraulic Tank (Hydrax) - Remove and Install
3508, 3508B, 3508C, 3512, 3512B, 3512C, 3516, 3516B and 3516C Engines Caterpillar Monitoring System Harness Code - Troubleshoot
G3500 Engines Carburetor - Disassemble - High Pressure
G3606 and G3608 Engines Hydraulic Oil Pump (Hydrax) - Remove and Install
G3500 Engines Carburetor - Install - Low Pressure
G3500 Engines Carburetor - Install - Low Pressure
G3500 Engines Carburetor - Install - High Pressure
G3500 Engines Carburetor - Remove - Low Pressure
3524B Engine for Caterpillar Built Machines Crankcase Breather - Remove and Install
3500B Engines Exhaust Elbow - Remove and Install
G3606 and G3608 Engines Junction Box (Hydrax) - Remove and Install
G3500 Engines Carburetor - Assemble - High Pressure
G3500 Engines Carburetor - Disassemble - High Pressure
3500B Engines and 3500 Engines with EUI Option Emergency Stop Switch
3034 Engine for Caterpillar Built Machines Turbocharger - Install
G3500 Engines Carburetor - Assemble - High Pressure
3114, 3116 and 3126 Industrial, Marine and Generator Set Engines Gear Group (Front)
G3500 Engines Electronic Sensor - Remove and Install
Electronic Modular Control Panel II (EMCP II) For PEEC Engines CID 331 FMI 2 Switch (Engine Control) Incorrect Signal - Test
G3500 Engines Fuel Control Actuator - Remove and Install
3500B Engines and 3500 Engines with EUI Option Engine Control Switch (ECS)
Electronic Modular Control Panel II (EMCP II) For MUI Engines CID 333 FMI 3 Alarm Module Control Voltage Above Normal - Test
G3500 Engines Fuel Control Valve - Remove and Install