Power Take-Off Clutch
Triple Plate Clutch
Show/hide table
Illustration 1 | g00511564 |
Typical Illustration |
Note: After clutch has been installed on engine, hit output shaft sharply on the end to relieve any preload that may result due to resistance of pilot bearing being pressed into the flywheel.
(1) Bearing Adjustment (End Clearance)
- Tighten bearing retainer until there is no clearance between cup and cone. Back off retainer two or three notches and assemble the lock. Strike output end of shaft to seat the inner bearing cup against the bearing retainer. Adjust to the following end play. ... 0.15 to 0.25 mm (.006 to .010 inch)
Clutch Engagement Check on the Engine
A torque of 295 to 392 N·m (214 to 291 lb ft) on the splined clutch lever shaft is required in order to engage the clutch.
Caterpillar Information System:
3306B Industrial Engine Power Take-Off Clutch
3176C and 3196 Engines For Caterpillar Built Machines Air Compressor - Remove and Install
3406E On-Highway Engine Camshaft Bearings - Install
3306B Industrial Engine Power Take-Off Clutch
3306B Industrial Engine Power Take-Off Clutch
3306B Industrial Engine Cylinder Head - Install
G3300 Engines Product Description
3408B and 3408C Industrial and Marine Engines Gear Group (Rear)
G3300 Engines Ignition Systems
3306B Industrial Engine Cold Weather Starting
3406C Engines for Caterpillar Built Machines Water Pump
3306B Industrial Engine Gauges and Indicators
3176C and 3196 Engines For Caterpillar Built Machines Fuel Priming Pump - Remove and Install
3176C and 3196 Engines For Caterpillar Built Machines Fuel Transfer Pump - Remove
3176C and 3196 Engines For Caterpillar Built Machines Fuel Transfer Pump - Install
G3300 Engines Model View Illustrations
3306B Industrial Engine Basic Block
3176C and 3196 Engines For Caterpillar Built Machines Electronic Unit Injector - Remove
3304B and 3306B Engines for Caterpillar Built Machines Rocker Shaft and Pushrod - Remove
3176C and 3196 Engines For Caterpillar Built Machines Electronic Unit Injector - Install
3306B Industrial Engine Electrical System
3176C and 3196 Engines For Caterpillar Built Machines Electronic Unit Injector Sleeve - Remove
3176C and 3196 Engines For Caterpillar Built Machines Engine Oil Pressure Sensor - Remove and Install
3304B and 3306B Engines for Caterpillar Built Machines Housing (Front) - Remove