Engine Oil Pump - Install
Installation Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install engine oil pump (4) onto the cylinder block. Ensure that idler gear (3) is engaged with the crankshaft gear and install locking tabs and bolts (2) . Install locking tabs and bolts (6) and (1) .
Show/hide table
Illustration 1 | g00484102 |
Show/hide table
Illustration 2 | g00465580 |
Show/hide table
The engine oil pump idler gear can fall off of the pump when the pump is removed or installed. Injury may result. To help prevent injury, always hold the idler gear on the pump when the pump is removed or installed. |
- Ensure that locking tab (5) is not next to the oil pan gasket when bolt (6) is tightened. Bend the locking tabs into position.
End By: Install the engine oil pan. Refer to Disassembly and assembly, "Engine Oil Pan - Remove and Install".
Caterpillar Information System:
Electronic Modular Control Panel II (EMCP II) For MUI Engines Speed Sensor (Engine) - Adjust
G3612 and G3616 Engines Exhaust Bypass Valve
Electronic Modular Control Panel II (EMCP II) For MUI Engines Alarm Module Control - Adjust
G3612 and G3616 Engines Status Control Module Service Procedure
3114, 3116, and 3126 Engines for Caterpillar Built Machines Engine Oil Filter Base - Disassemble
3114, 3116, and 3126 Engines for Caterpillar Built Machines Engine Oil Filter Base - Assemble
Electronic Modular Control Panel II (EMCP II) For MUI Engines AC Voltage Range - Adjust
Electronic Modular Control Panel II (EMCP II) For MUI Engines Electrical Connector - Inspect
G3606 and G3608 Engines Choke Trim
G3606 and G3608 Engines Governor Adjustment Procedure
Electronic Modular Control Panel II (EMCP II) for EUI Engines Inaccurate Display of Voltage or Current - Troubleshoot
G3500B Engines Throttle Control Linkage
Electronic Modular Control Panel II (EMCP II) For MUI Engines Charging System - Test
Electronic Modular Control Panel II (EMCP II) for EUI Engines Starting Motor Magnetic Switch - Test
G3612 and G3616 Engines Camshaft
3306C Truck Engine Pistons and Connecting Rods - Remove
3306C Truck Engine Pistons and Connecting Rods - Install
C-10 and C-12 Truck Engines Basic Block
3612 and 3616 Engines Gear Group (Rear)
Electronic Modular Control Panel II (EMCP II) For MUI Engines EMCP Electronic Control (AC Transformer Box) - Replace
Electronic Modular Control Panel II (EMCP II) For MUI Engines EMCP Electronic Control (Generator Set) - Replace
Electronic Modular Control Panel II (EMCP II) For MUI Engines Relay Module - Replace
Electronic Modular Control Panel II (EMCP II) for EUI Engines Typical Generator Abbreviations
C-10 and C-12 Truck Engines Engine Oil Pan