Speed Sensor (Engine) - Adjust
Show/hide table
Illustration 1 | g00289497 |
Speed Sensor (1) Speed sensor (2) Locknut (A) Air gap |
This adjustment procedure is for the engine speed sensor.
- Remove the speed sensor (1) from the flywheel housing. Remove all debris from the tip of the speed sensor. Align a ring gear tooth directly in the center of the threaded sensor opening.
- By hand, screw the speed sensor (1) into the hole until the end of the sensor contacts the gear tooth.
- Turn the sensor (1) in the counterclockwise direction through 270 degrees (three-fourths turn).
- Tighten locknut (2) to 25 ± 5 N·m (18 ± 4 lb ft).
Note: Do not allow speed sensor (1) to turn as locknut (2) is tightened.
Caterpillar Information System:
G3612 and G3616 Engines Exhaust Bypass Valve
Electronic Modular Control Panel II (EMCP II) For MUI Engines Alarm Module Control - Adjust
G3612 and G3616 Engines Status Control Module Service Procedure
3114, 3116, and 3126 Engines for Caterpillar Built Machines Engine Oil Filter Base - Disassemble
3114, 3116, and 3126 Engines for Caterpillar Built Machines Engine Oil Filter Base - Assemble
Electronic Modular Control Panel II (EMCP II) For MUI Engines AC Voltage Range - Adjust
Electronic Modular Control Panel II (EMCP II) For MUI Engines Electrical Connector - Inspect
G3606 and G3608 Engines Choke Trim
G3606 and G3608 Engines Governor Adjustment Procedure
Electronic Modular Control Panel II (EMCP II) for EUI Engines Inaccurate Display of Voltage or Current - Troubleshoot
G3500B Engines Throttle Control Linkage
G3606 and G3608 Engines Engine Timing Procedures
3306C Truck Engine Engine Oil Pump - Install
Electronic Modular Control Panel II (EMCP II) For MUI Engines Charging System - Test
Electronic Modular Control Panel II (EMCP II) for EUI Engines Starting Motor Magnetic Switch - Test
G3612 and G3616 Engines Camshaft
3306C Truck Engine Pistons and Connecting Rods - Remove
3306C Truck Engine Pistons and Connecting Rods - Install
C-10 and C-12 Truck Engines Basic Block
3612 and 3616 Engines Gear Group (Rear)
Electronic Modular Control Panel II (EMCP II) For MUI Engines EMCP Electronic Control (AC Transformer Box) - Replace
Electronic Modular Control Panel II (EMCP II) For MUI Engines EMCP Electronic Control (Generator Set) - Replace
Electronic Modular Control Panel II (EMCP II) For MUI Engines Relay Module - Replace
Electronic Modular Control Panel II (EMCP II) for EUI Engines Typical Generator Abbreviations