Engine Oil Cooler Bypass and Cooling Jet Sequence Valves
Show/hide table
Illustration 1 | g00295321 |
Right Side View Typical Illustration |
(1) Tighten the bolts to the following torque. ...
Procedure to tighten clamp bolts
- Tighten the clamp assembly snugly to the tube.
- Tighten the clamp assembly to the elbow.
- Tighten the clamp assembly to the tube.
(2) Tighten the plug to the following torque. ...
(3) 6B-9202 Spring for the cooling jet sequence valve
- Length under test force ...
68.3 mm (2.69 inch) - Test force ...
85 to 102 N (19 to 23 lb) - Free length after test ...
112.7 mm (4.44 inch) - Outside diameter ...
24.60 mm (.969 inch) - Test force ...
Note: There is a spring at each end of the block.
Both of the cooling jet sequence valves must start to open at the following pressure difference. ...
Both of the cooling jet sequence valves must be fully open at the following pressure difference. ...
(4) 2W-1635 Spring for oil cooler bypass valve
- Length under test force ...
102 mm (4.02 inch) - Test force ...
492 to 544 N (111 to 122 lb) - Free length after test ...
143.4 mm (5.65 inch) - Outside diameter ...
37.25 mm (1.467 inch) - Test force ...
The oil cooler bypass valve must open with the following pressure difference. ...
Caterpillar Information System:
3500 Engines for Caterpillar Built Generator Sets Camshaft
3500 Generator Set Engines Camshaft
3306C Truck Engine Engine Design
3500B and 3500B High Displacement Generator Set Engines Prelube Pump
3306B Industrial Engine Magnetic Switch
3500 Generator Set Engines Aftercooler
Disassembly And Assembly Of The 144-0835 Unit Injector Hydraulic Pump Disassembly And Assembly Of The 144-0835 Unit Injector Hydraulic Pump
3500B Locomotive Engines Air Inlet and Exhaust Lines
G3612 and G3616 Engines Ignition System Spark Plugs - Check/Adjust
3500B and 3500B High Displacement Generator Set Engines Air Inlet and Exhaust Lines
G3612 and G3616 Engines Gas Pressure Regulator - Inspect/Replace
3054 Engine Electric Starting Motor
3500 Generator Set Engines Engine Oil Filter
C15 and C18 Petroleum Generator Sets Engine Rating Definitions
C15 and C18 Petroleum Generator Sets Gauges and Indicators
3500 Generator Set Engines Fan Drive
3500 Generator Set Engines Flywheel Housing Cover
3306C Truck Engine Fuel Injection Lines
G3612 and G3616 Engines Combustion Sensor - Clean/Inspect/Replace
3500 Engines for Caterpillar Built Generator Sets Exhaust Manifold
Alignment of Single-Bearing Generators {4471} Alignment of Single-Bearing Generators {4471}
3306C Engines for Caterpillar Built Machines Fuel Injection Nozzles
3500B Engines Thermostatic Valve
G3612 and G3616 Engines Valve Stem Projection - Measure/Record