Conveyor Drive Chain (Drag) - Check and Adjust
Show/hide table
柴油发动机的排气含有可伤害人体的燃烧产物。 必须要在通风良好的地方起动发动机,如果在密闭的地方起动,就要把排气通到外面。 |
Show/hide table
旋转和运动的部件会造成人身伤害。 应避开所有旋转和运动的部件。 机器移动或发动机运转时决不能试图进行部件的调整工作,除非另有规定。 机器必须停在水平地面上,且发动机停止运转。 维修、修理或调整机器前,在起动开关和控制装置上要贴上"禁止操作"或类似的警告标签。 |
- 把机器开到平整水平的路面。
Show/hide table
图 1 g03727958 - 将行驶方向开关 (1) 移到空档位置。
- 将行驶速度旋钮 (2) 逆时针转至最小位置。
Show/hide table
图 2 g03727959 - 将停车制动器操纵杆 (3) 移到接通位置。
Show/hide table
图 3 g03727961 - 将油门操纵杆 (4) 移到低怠速位置。
Show/hide table
图 4 g03727962 - 将锁 (5) 移到一旁,然后将熨平板提升杆 (6) 移到浮动位置。 将熨平板降至地面。
Show/hide table
图 5 g03727963 - 将发动机起动开关 (7) 移到 OFF(断开)位置。
Show/hide table
图 6 g03728206 - 解锁锁闩 (19) 并打开左侧舱室 (18)。
Show/hide table
图 7 g03727965 (A) 11 ± 1 mm (0.43 ± 0.039 inch) - 测量链条的挠度。 链条中点的挠度应为
11 ± 1 mm (0.43 ± 0.039 inch) (A)。 - 如果挠度不在规定范围内,转至步骤 11,如果挠度在规定范围内,转至步骤 12。
- 采用以下步骤来调整链条张力:
- 松开但不要拆下四个螺栓 (10)。
Show/hide table
图 9 g03728210 - 松开锁紧螺母 (11)。
- 顺时针转动调整螺栓 (12) 以拧紧传动链。
- 逆时针转动调整螺栓 (12) 以拧松传动链。
- 固定调整螺栓 (12)。
- 拧紧锁紧螺母 (11)。
- 拧紧螺栓 (10)。
- 进行第 9 步。
Show/hide table图 8 g03728209 - 松开但不要拆下四个螺栓 (10)。
- 关闭左侧舱室 (18),然后锁止锁闩 (19)。
Caterpillar Information System:
785G Off-Highway Truck Capacities (Refill)
785G Off-Highway Truck Systems Transmission Hydraulic Control
M318F, M320F and M322F Wheeled Excavators and MH3022 and MH3024 Material Handlers Sound Information and Vibration Information
C4.4 Engines NOx Sensor - Test
773E Off-Highway Truck Power Train Transmission Control
C4.4 Engines Motorized Valve - Test
M318F, M320F and M322F Wheeled Excavators and MH3022 and MH3024 Material Handlers Backup Controls
C3.4B Engines Motorized Valve - Test
C4.4 Engines Mode Selection - Test
C4.4 Engines Injector Solenoid - Test
C4.4 Engines Injector Data Incorrect - Test
C4.4 Engines Indicator Lamp - Test
AP255E Asphalt Paver Machine Systems Conveyor Chain (Drag) - Adjust
2014/09/22 Improved Retention of Fasteners {5622}
M318F, M320F and M322F Wheeled Excavators Hydraulic System Piston Pump (Fan Drive)
785G Off-Highway Truck Systems Temperature Sensor (Steering Oil)
AP255E Asphalt Paver Machine Systems Heater Element - Test
M318F, M320F and M322F Wheeled Excavators Hydraulic System Pump Control - Fan
785G Off-Highway Truck Systems Pressure Switch - Manifold Bypass
Procedure to Inspect and Rework the Frame 4 Bar Casting to Main Rail Connection Offset on the 793F Off-Highway Truck {0679, 7051} Procedure to Inspect and Rework the Frame 4 Bar Casting to Main Rail Connection Offset on the 793F Off-Highway Truck {0679, 7051}
2014/09/26 The Brake Control Group has been Improved on the 795F AC Off-Highway Truck {4257, 4265, 4269}
826K Landfill Compactor, 825K Soil Compactor and 824K Wheel Dozer Machine Systems Steering Control Valve - Assemble
785G Off-Highway Truck Systems Steering Accumulator
826K Landfill Compactor, 825K Soil Compactor and 824K Wheel Dozer Machine Systems Steering Control Valve - Disassemble