2014/04/24 Caterpillar


A Procedure to Install the Cold Weather Cover Group onto Certain 773G, 775G and 777G Off-Highway Trucks is Available {1408, 7155, 7170, 7315, 7610, 7620, 795C}

Usage:

777G GT7
Off-Highway Truck/Tractor:
777G (S/N: T5A1-UP; TNM1-UP; RDR1-UP; T4Y1-UP; GT71-UP)
Quarry Truck:
773G (S/N: MWH1-UP; JWS1-UP; T5S1-UP; T5T1-UP)
775G (S/N: T5F1-UP; RFM1-UP; MJS1-UP; T5W1-UP)
Service Magazine SEPD1774, 24 April 2014, "A Procedure to Install the Cold Weather Cover Group onto Certain Off-Highway Trucks is Available". Disregard this article. Refer to the article that follows.

The new special instructions contains information that is needed to install the cold-weather cover group onto certain Off-Highway Trucks. The cold-weather group will improve the machines performance while operating in cold climate.

For a complete list of material and the correct procedure that is needed in order to install the cold-weather cover group, refer to Special Instruction, REHS9320, "Procedure to Install the Cold Weather Cover Group onto Certain Tier IV 773G, 775G and 777G Off-Highway Trucks" or Special Instruction, REHS9329, "Procedure to Install the Cold Weather Cover Group onto Certain Tier II 773G, 775G and 777G Off-Highway Trucks". The special instructions can be found on the Caterpillar service information system (SIS) and through the normal literature distribution system at your local Cat dealer.

Operating Conditions

Table 1
Operating Conditions for the use of the 449-0978 Cover Gp and the 449-8545 Cover Gp    
Ambient Temperature     Operating Machine     Machine Extended Idle    

−40° C (−40° F) and Below    
Cover closed     Cover closed    

−40° C (−40° F) to
0° C (32° F)    
Cover half open     Cover closed    

0° C (32° F) to
15° C (59° F)    
Cover fully open     Cover closed    

15° C (59° F) and Above    
Remove cover     Remove cover    



    Illustration 1g03604000

    View of the cover group closed 777G




    Illustration 2g03620577

    View of the cover group closed 773G/775G

  1. When the machine is at extended idling over 5 minutes or machine is operating in a temperature of −40° C (−40° F) and below, close the cover group.



    Illustration 3g03604096

    View of the cover group half-way open 777G




    Illustration 4g03620604

    View of the cover group half-way open 773G/775G

  1. When operating the machine in temperatures between −40° C (−40° F) to 0° C (32° F) open half, top or bottom, of the cover group,



    Illustration 5g03604176

    View of the cover group fully opened 777G




    Illustration 6g03620618

    View of the cover group fully opened 773G/775G

  1. When operating the machine in temperatures between 0° C (32° F) to 15° C (59° F) fully open (top and bottom) of the cover group.



    Illustration 7g03604198

    View of the cover group removed 777G




    Illustration 8g03620641

    View of the cover group removed 773G/775G

  1. When operating the machine in temperature 15° C (59° F) and above, remove the cover group.

Caterpillar Information System:

C4.4 Engines for Caterpillar Built Machines Piston and Rings
994K Wheel Loader Hydraulic System Oil (Implement) (Hydraulic Fan) - Change
Product Link 121S/300 ECM Does Not Communicate with User Interface
Product Link 121S/300 System Schematic
Product Link 121S/300 Specifications
Product Link 121S/300 Wiring Harness (Short Circuit) - Test
Product Link 121S/300 Wiring Harness (Open Circuit) - Test
12M Series 3, 140M Series 3 and 160M Series 3 Motor Graders Diesel Exhaust Fluid Tank
Product Link 121S/300 Electrical Connector - Inspect
Product Link 121S/300 Electronic Control Module (ECM) - Replace
C4.4 Engines for Caterpillar Built Machines Engine Oil Pump
Product Link 121S/300 Electronic Control Module (ECM) - Flash Program
Procedure to Install the Cold Weather Cover Group onto Certain Tier IV 773G, 775G and 777G Off-Highway Trucks{1408, 7155, 7170, 7315, 7610, 7620, 795C} Procedure to Install the Cold Weather Cover Group onto Certain Tier IV 773G, 775G and 777G Off-Highway Trucks{1408, 7155, 7170, 7315, 7610, 7620, 795C}
966M and 972M Wheel Loaders Power Train, Steering, Braking, Hydraulic, and Machine Systems Brake System Air - Purge
2014/02/20 The New Improved Bevel Gear and Bevel Pinion Shaft Is Now Used on Certain 16M Motor Graders {3254, 3256}
980M and 982M Wheel Loaders Power Train, Steering, Braking, Hydraulic, and Machine Systems Transmission Pressures - Test and Adjust
2014/02/28 Improved Cab Heater Group, with Improved Water Valve and New Heater Box Access Panels to Improve Serviceability, Is Now Used on Certain Pipelayers, Track-Type Loaders, and Track-Type Tractors {7304, 7320}
994K Wheel Loader Hydraulic System Oil (Steering, Brake) - Change
Ethernet Switch Wiring to Allow for Proper VIMS Initialization and Cat® MineStar Fleet Onboard Start Up and Shut Down Messaging {7601, 7605, 7610} Ethernet Switch Wiring to Allow for Proper VIMS Initialization and Cat® MineStar Fleet Onboard Start Up and Shut Down Messaging {7601, 7605, 7610}
2014/02/04 Upgraded Software is Now Available For Cat® MineStar Office Systems v3.1.1 {7610, 7620}
2014/02/04 The Installation of the Front Suspension Group Has Been Updated for the 789D Off-Highway Truck {7000, 7200, 7201, 7960}
Procedure to Check Clutch Pressures using Updated Software and Cat Electronic Technician on Certain Off-Highway Trucks{3160, 4800, 4808, 7610, 7620} Procedure to Check Clutch Pressures using Updated Software and Cat Electronic Technician on Certain Off-Highway Trucks{3160, 4800, 4808, 7610, 7620}
794 AC Off-Highway Truck VIMSTM 3G and Truck Payload Measurement System (TPMS) Electrical Output Components
794 AC Off-Highway Truck VIMSTM 3G and Truck Payload Measurement System (TPMS) Electronic Control Module
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.