Start By:
- Release system pressure.
- Remove the transport guard.
| Required Tools | |||
| Tool | Part Number | Part Description | Qty |
| A | 187-0500 | Tool-Sleeve | 1 |
| B | 4C-4030 | Thread Lock Compound | 1 |
 |
|
Accidental machine starting can cause injury or death to personnel working on the machine. To avoid accidental machine starting, turn the battery disconnect switch to the OFF position and remove the key. If the machine is not equipped with a battery disconnect switch, disconnect the battery cables from the battery and tape the battery clamps. Place a do not operate tag at the battery disconnect switch location to inform personnel that the machine is being worked on. |
|
|
Personal injury can result from rotating and moving parts. Stay clear of all rotating and moving parts. Never attempt adjustments while the machine is moving or the engine is running unless otherwise specified. The machine must be parked on a level surface and the engine stopped. |
| NOTICE |
|---|
|
When you change the disc saw teeth or holders, always replace the used bolts with new bolts. Use extreme cleanliness and properly torque the bolts upon installation. Failure to ensure cleanliness and to properly torque the bolts may result in machine damage. |
- Remove bolts (2) from tooth holder (4).
- Use Tooling (A) to remove sleeve nut (5).
- Remove sleeve head (3).
- Remove tooth holder (4) from disc saw (1).
| |
| Illustration 1 | g00939136 |
| |
| Illustration 2 | g00939137 |
- Install tooth holder (4) in the reverse order of removal.
- Apply Tooling (B) to bolts (2). Tighten bolts (2) to a torque of
170 ± 20 N·m (125 ± 15 lb ft) .
- Apply Tooling (B) to bolts (2). Tighten bolts (2) to a torque of