770G and 772G Off-Highway Truck/Tractors Caterpillar

A Machine Electronic Control Module (ECM) must be configured at the time of installation. The ECM will not function properly if the control module has not been configured. When the ECM is configured, the model number of the machine is set.

Cat Electronic Technician (ET) is used to access the configuration screen . A message on the Cat ET screen will give instructions that guide the user through the procedure.

"ET Configuration Procedure"

1. Turn the keyswitch to the OFF position.

2. Connect Cat ET the service tool connector.

3. Turn the keyswitch to the ON position.

4. Select the Machine ECM.

5. You are on the main menu. Select the "Service Configuration" menu item. Double click to select the appropriate sales model.

6. Select a sales model.

   Note: After selecting the correct sales model, Cat ET will exit out of the configuration menu.

7. Cycle power with the keyswitch. Leave the keyswitch in the OFF position for a minimum of 10 seconds.

8. With the key start switch returned to the ON position, Cat ET will initiate communications with all ECM modules on the machine.

9. Select the Machine ECM.

10. From the main menu, select the "Service Configuration" menu item.

11. Click on the "Data Link Disconnect" button.

12. Disconnect the ET from the service tool connector.

13. Turn the keyswitch to the OFF position.