Usage:
Start By:
a. remove cylinder head
1. Remove seals (1) from the spacer plate.
2. Install six 3/8" -16 NC forcing screws (3) in the spacer plate. Tighten the screws evenly until the plate is free of the dowels on the cylinder head.
NOTICE |
---|
Do not damage dowels (2) as the plate is removed. |
Install Spacer Plates
1. Make sure the spacer plate and the machined surface (3) of the cylinder block are clean and free of dirt and foreign material.
2. Install O-ring seals (1).
3. Put a new gasket into position over dowels (3) on the cylinder block.
4. Install spacer plate (4).
NOTICE |
---|
Both surfaces of the spacer plate, gasket and the top of the cylinder block must be clean. Do not use a gasket adhesive or other substances of these surfaces. |
5. Install a new washer seals in the spacer plate.
6. Check the cylinder liner projection. See Install Cylinder Liners.
End By:
a. install cylinder head