Perform continuity checks at the harness connectors in order to locate harness failures. At the connectors of the components, always check the ground circuit. There must be less than five ohms of resistance between any system ground and the frame ground. Excessive ground resistance that is greater than five ohms can cause incorrect diagnosing of problems.
During troubleshooting, inspect all connections before any component is replaced. If these connections are not clean and tight, permanent electrical problems or intermittent electrical problems can result. Check that the wires are pushed into the connectors completely. Make sure that the connections are tight before other tests are made.
Failure of an electrical component can cause the failure of other components. Also, failure of an electrical component can be caused by the failure of other components. Always attempt to correct the cause of an electrical system failure before you replace a component.
Technical Assistance
Contact your Caterpillar dealership for assistance with any problems that are not covered in this manual.
Warnings
 |
Do not operate or work on this machine unless you have read and understand the instructions and warnings in the Operation and Maintenance Manuals. Failure to follow the instructions or heed the warnings could result in injury or death. Contact your Caterpillar dealer for replacement manuals. Proper care is your responsibility. |
 |
|
Falling Hazard. Do not climb onto the drum in order to access the GPS receiver. Climbing on the drum could result in a fall which could cause serious injury or death. Use the raise and lower mechanism to access the GPS receiver for all required maintenance and service. For more information, refer to Operation and Maintenance Manual, "Getting Started". |
|