Make sure that all of the safety signs are legible. Clean the safety signs or replace the safety signs if you cannot read the words. Replace the illustrations if the illustrations are not legible. When you clean the safety signs, use a cloth, water and soap. Do not use solvent, gasoline, or other harsh chemicals to clean the safety signs. Solvents, gasoline, or harsh chemicals could loosen the adhesive that secures the safety sign. Loose adhesive will allow the safety sign to fall.
Replace any safety sign that is damaged, or missing. If a safety sign is attached to a part that is replaced, install a safety sign on the replacement part. Any Caterpillar dealer can provide new safety signs.
 | |
| Illustration 1 | g01845693 |
Area Isolation System Barrier Control | |
Electrical Panels (1)
This safety message is located on the Power Supply Panel, AIS Transmitter Panel and the Barrier Control Panel.
 | |
| Illustration 2 | g01620296 |
 |
Shock/Electrocution Hazard – Do not operate this equipment or work on this equipment unless you have read and understand the instructions and warnings in the Service Manual. Failure to follow the instructions or heed the warnings will result in serious injury or death. |
 |
Operations Area Entry
 | |
| Illustration 3 | g01695353 |
Plan view (2) Message (3) Entrance (4) Laser Detection and Ranging (LADAR) (5) Operations area | |
Message (2) is placed at a location that is visible to personnel at entrance (3) to operations area (5) .
AIS Strobe Light (2)
This message is located at each entrance to the operations area.
 | |
| Illustration 4 | g01675273 |
|
Remote controlled machines operate in this area. Personal injury or death could result from entry to this area. Do not enter this area when the Area Isolation System red warning light is flashing. Refer to the Operation and Maintenance Manual for operations area access instructions. |
|
AIS LADAR (Laser) (4)
This laser is classified as a Class 1 laser product according to IEC 60825-1:2007 - Safety of laser products - Part 1: Equipment classification and requirements and Part 21 of the Code of Federal Regulations (USA) Section 1040.10 (21CFR1040.10). The laser complies with the applicable portions of 21CFR1040 (1Apr2008).
Refer to the operator's manual of the laser transmitter for installation and operating instructions.
The laser that is supplied with the MINEGEM system complies with all applicable portions of "Title 21" of the "Code of Federal Regulations, Department of Health and Human Services, Food and Drug Administration, Federal Register, Volume 50, Number 161, 20August 1985".
This laser complies with "OSHA Standards Act, Section 1518.54" for use without eye protection. Eye protection is not required or recommended. The following safety rules should be observed:
- Never look into a laser beam or point the beam into the eyes of other people. Set the laser at a height that prevents the beam from flashing directly into people's eyes.
- Do not remove any warning signs from the laser.
- Use of this product by personnel that are not trained on this product may result in exposure to hazardous laser light.
- If initial service requires the removal of the outer protective cover, removal of the cover must be performed by trained personnel.